292323-6 TE Connectivity, 292323-6 Datasheet - Page 6

• Manufacturer Part Number: 292323-6
• Manufacturer: TE Connectivity
• Series: Ar

Specifications of 292323-6

• Size: Standard
• Gender: Receptacle
• Number Of Ports: 2
• Orientation: Right Angle
• Mount Location: Top
• Panel Ground Type: Ground Finger
• Termination Method: Solder
• Tail Length (mm [in]): 3.24 [0.128]
• Locking Feature: Without
• Led: Without
• Panel Ground: With
• Pcb Mount Retention Type: Kinked Leg(s)
• Shell Plating: Bright Tin
• Assembly Process Feature: Without Pick and Place Cover
• Locating Post(s): Without
• Number Of Positions: 4
• Contact Termination Type: Through Hole
• Contact Plating, Mating Area, Material: Gold or Gold Flash over Palladium Nickel
• Contact Plating, Mating Area, Thickness (µm [?in]): 0.762 [30]
• Housing Color: Black
• Industry Standard: USB 2.0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Usb-if Test Id Number (tid): Not Submitted For Testing
• Applies To: Printed Circuit Board
• Pcb Thickness, Recommended (mm [in]): 1.57 [0.062]
• Panel Ground Location: Center
• Packaging Method: Tray

ASHL-0005- ES REV A
4.2
4.3
4.4
If changes significantly affecting form, fit or function is made to be product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original
testing sequence as determined by development/product, quality and reliability engineering.
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted for qualification. Testing to confirm
corrective action is required before resubmitted.
Applicable AMP quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Requalification Testing
Acceptance
Quality Conformance Inspection
B.
Acceptance is based on verification that the product meets requirement of Figure 1.Failures attributed
connectors. A minimum of 30 contacts shall be selected and identified for each test group.
Unless otherwise specified, these contacts shall be used for all measurements.
Test Sequence
Qualification inspection shall be verified testing samples as specified in Figure 2.
AMP Shanghai Ltd
Tyco Electronics
PAGE NO
6
108-60034
REV LOC
O
ES