1600636-6 TE Connectivity, 1600636-6 Datasheet - Page 4

• Manufacturer Part Number: 1600636-6
• Manufacturer: TE Connectivity

Specifications of 1600636-6

• Product Series: XL
• Connector Type: Connector Assembly
• Termination Style: Panel
• Mating Type: Blindmate
• Guides: With
• Mating Functionality: Mate First-Break Last
• Voltage Rating (signal) (vac): 60
• Voltage Rating (power) (vac): 300
• Voltage Rating (power) (vdc): 200
• Sequencing: Yes
• Connector Configuration Orientation: Right-to-Left
• Centerline, Dc Module (mm [in]): 6.35 [0.250]
• Centerline, Ac Module (mm [in]): 7.62 [0.300]
• Centerline, Matrix (mm [in]): 2.54 x 2.54 [.100 x .100]
• Contact Type: Socket
• Connector Style: Receptacle
• Housing Material: Thermoplastic - GF
• Total Number Of Dc Power: 12
• Total Number Of Ac Power: 4
• Total Number Of Signal: 24
• Connector Contact Configuration (no. Of Pos./type): 4/AC Power, 24/Signal, 12/DC Power
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Application Use: Cable-to-Board

Rev C
Unmating force.
Contact insertion force, power
contacts.
Contact retention, straight pull.
Contact retention, angled pull.
Housing lock strength, straight pull. 25 pounds minimum.
Housing lock strength, angles pull.
Test Description
8 ounce minimum per power
contact.
.7 ounce minimum per signal
contact.
6 pounds maximum.
30 pounds minimum for power
contact.
3 pounds minimum for signal
contact.
Figure 3 (cont)
Requirement
EIA-364-13.
Measure force necessary to
unmate specimens at a maximum
rate of 1 inch per minute. Size
signal contacts 3 times using gage
1, then insert gage 2 and measure
force necessary to separate.
See Figure 5.
EIA-364-5.
Measure force necessary to insert
contact into housing.
EIA-364-29.
Apply axial load to wire, as crimped
to contacts. Power contact
retention shall be qualified with
TPA lock and primary lance(s)
engaged. Signal contact retention
shall be qualified in 2 independent
modes: 1) primary lance only: and
2) secondary TPA lock only.
Signal TPA lock shall withstand 3
pounds minimum on a singly
loaded wire.
Apply load to single wires at a 45
degree angle in 4 directions from
normal exit plane of cable. Both
power and signal contact shall be
qualified with TPA locks and
primary lance(s) engaged.
EIA-364-98.
Apply axial force to mated pair
using securely mounted vertical
header (4-40 cap screw and nut
through mounting hole and printed
circuit board). Apply force in
straight pull in direction normal to
plane of cable entrance.
Apply load to wire bundle of mated
pair at a 45 degree angle in 4
directions from the normal exit
plane of the cable connector with
the mated vertical header securely
mounted.
Procedure
108-2157
4 of 9