TDA9898HN/V3,551 NXP Semiconductors, TDA9898HN/V3,551 Datasheet - Page 24

• Manufacturer Part Number: TDA9898HN/V3,551
• Description: IC IF PROCESSOR HYBRID 48-HVQFN
• Manufacturer: NXP Semiconductors
• Type: Demodulatorr

Specifications of TDA9898HN/V3,551

• Applications: TV
• Mounting Type: Surface Mount
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 935288218551

NXP Semiconductors
UJA1076_2
Product data sheet
6.10 Temperature protection
6.9 Interrupt output
Pin INTN is an active-LOW, open-drain interrupt output. It is driven LOW when at least
one interrupt is pending. An interrupt can be cleared by writing 1 to the corresponding bit
in the Int_Status register
interrupt status bit and not the pending wake-up. The pending wake-up is cleared on
entering Normal mode and when the corresponding standby control bit (STBCC) is 0.
On devices that contain a watchdog, the Cyclic Interrupt (CI) is enabled when the
watchdog switches to Timeout mode while the SBC is in Standby mode or Normal mode
(provided WDOFF = LOW). A CI is generated if the watchdog overflows in Timeout mode.
The CI is provided to alert the microcontroller when the watchdog overflows in Timeout
mode. The CI will wake up the microcontroller from a μC standby mode. After polling the
Int_Status register, the microcontroller will be aware that the application is in cyclic wake
up mode. It can then perform some checks on CAN before returning to the μC standby
mode.
The temperature of the SBC chip is monitored in Normal and Standby modes. If the
temperature is too high, the SBC will go to Overtemp mode, where the RSTN pin is driven
LOW and limp home is activated. In addition, the voltage regulators and the CAN
transmitter are switched off (see also
temperature falls below the temperature shutdown threshold, the SBC will go to Standby
mode. The temperature shutdown threshold is between 165 °C and 200 °C.
All information provided in this document is subject to legal disclaimers.
Rev. 02 — 27 May 2010
(Table
7). Clearing bit CWI in Standby mode only clears the
Section 6.1.6 “Overtemp
High-speed CAN core system basis chip
mode”). When the
UJA1076
© NXP B.V. 2010. All rights reserved.
24 of 47