P1200S Teccor Electronics, P1200S Datasheet - Page 103

• Manufacturer Part Number: P1200S
• Description: solid state crowbar devices
• Manufacturer: Teccor Electronics

Figure 3.17 T1/E1 Protection
© 2002 Teccor Electronics
SIDACtor
COT
Transceiver
®
T1
Data Book and Design Guide
RX
TX
The peak voltage for 120 V rms is 169.7 V. The minimum stand-off voltage for the P1800 is
170 V, therefore, the P1800SC MC will pass the test in Section 4.4.5.2 by not allowing
10 mA of current to flow during the application of this test voltage.
For the transceiver side of the coupling transformer, additional overvoltage protection is
shown in Figure 3.17 using the P0300SA SIDACtor device. When an earth ground
connection is not used, only metallic protection is required. Metallic protection is satisfied
using a single P0640SC MC SIDACtor device across Tip and Ring and a single F1250T
TeleLink fuse on either Tip or Ring.
Component Selection
The “SC MC” SIDACtor device and F1250T TeleLink fuse were chosen because these
components meet GR 1089 surge immunity requirements without the use of additional
series resistance. An MC is chosen to reduce degradation of data rates. The voltage rating
of the P1800SC MC was selected to ensure loop powering up to 150 V. The voltage rating
of the P0640SC MC was selected to ensure coordination with varying voltage signals.
P0300SA
P0300SA
exceed 10 mA
on the complete equipment or device, the test may be carried out
separately on components, subassemblies, and simulated circuits,
outside the unit, provided that the test results would be representative of
the results of testing the complete unit.
Power
Source
PK
P1800SC MC
P1800SC MC
P1800SC MC
P1800SC MC
at any time. As an alternative to carrying out this test
F1250T
F1250T
F1250T
F1250T
3 - 15
Regenerator
F1250T
F1250T
P0640SC MC
P0640SC MC
High Speed Transmission Equipment
http://www.teccor.com
RX
TX
Transceiver
[phone]
T1