P1200S Teccor Electronics, P1200S Datasheet - Page 128

• Manufacturer Part Number: P1200S
• Description: solid state crowbar devices
• Manufacturer: Teccor Electronics

GR 1089–Core
Table 4.1 Test Conditions
Notes:
• When performing longitudinal tests, the test generator will have a dual output.
• Refer to Table 4.2 for switch positions for each test condition.
Table 4.2 Connections to Test Generator
Note: Other outside plant leads associated with the unit should be grounded during the test and the test repeated with these leads
Figure 4.1 Connection Appearances
http://www.teccor.com
[phone]
Condition A-1 of Table 4.1
Condition A-2 of Table 4.1
Condition A-3 of Table 4.1
Test
A
B
terminated as in service. Leads that do not connect to outside plant should be terminated as appropriate for the operating
mode(s) of the unit.
1. Tip to Generator, Ring to Ground
2. Ring to Generator, Tip to Ground
3. Tip and Ring to Generator simultaneously
Tip and Ring to Generator simultaneously
Voltage
Source
Condition
Test Generator
(If Specified)
Resistance
Limiting
Passing Criteria
Passing criteria for the First Level Lightning Surge Test and the First Level AC Power Fault
Test is that the EUT will not be damaged and that it will operate as intended after the stress
is removed. Passing criteria for the Second Level Lightning Surge Test and Second Level
Two-wire Interface
S1
S3
Closed
Closed
Open
S1
S2
S4
Ring
Tip
4 - 4
1. Each lead (T, R, T
2. Tip and Ring to Generator, simultaneously; T
3. T
T, R, T
leads grounded
Ground
Ground
1
Closed
Open
Open
and R
S2
1
, R
1
1
to Generator simultaneously
Switch Unit
Under Test
to Generator, simultaneously; Tip and Ring to
SIDACtor
1
, R
Four-wire Interface
1
) to the Generator with the other three
Closed
Closed
Open
S3
®
Data Book and Design Guide
© 2002 Teccor Electronics
Associated
Outside
Plant
Leads
1
and R
T
E
R
M
Closed
Open
Open
S4
1
to
T
E
R
M