CD016G0PFA Advanced Micro Devices, Inc., CD016G0PFA Datasheet - Page 68

• Manufacturer Part Number: CD016G0PFA
• Description: 16 Megabit(512 K X 32-Bit),CMOS 2.5 Volt-only Burst Mode, Dual Boot, Simultaneous Read/write Flash Memory
• Manufacturer: Advanced Micro Devices, Inc.

Absolute Maximum Ratings
Notes:
1. Minimum DC voltage on input or I/O pins is –0.5 V. During voltage transitions, input at I/O pins may overshoot V
2. Minimum DC input voltage on pins ACC, A9, OE#, and RESET# is -0.5 V. During voltage transitions, A9, OE#, and
3. No more than one output may be shorted to ground at a time. Duration of the short circuit should not be greater
4. Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is
Operating Ranges
Operating ranges define those limits between which the functionality of the device is guaranteed.
68
+0.8 V
–0.5 V
–2.0 V
to –2.0 V for periods of up to 20 ns. See 9. Maximum DC voltage on output and I/O pins is 3.6 V. During voltage
transitions output pins may overshoot to V
RESET# may overshoot V
A9 and OE# is +13.0 V which may overshoot to 14.0 V for periods up to 20 ns.
than one second.
a stress rating only; functional operation of the device at these or any other conditions above those indicated in the
operational sections of this data sheet is not implied. Exposure of the device to absolute maximum rating conditions
for extended periods may affect device reliability.
Figure 8. Maximum Negative Overshoot
Storage Temperature, Plastic Packages . . . . . . . . . . . . . . . . –65°C to +150°C
Ambient Temperature with Power Applied . . . . . . . . . . . . . . –65°C to +145°C
V
ACC, A9, OE#, and RESET# (Note 2) . . . . . . . . . . . . . . . . . –0.5 V to +13.0 V
Address, Data, Control Signals
Output Short Circuit Current (Note 3). . . . . . . . . . . . . . . . . . . . . . . . 200 mA
Industrial (I) Devices
Ambient Temperature (T
Extended (E) Devices
Ambient Temperature (T
V
V
V
V
CC
CC
IO
20 ns
CC
IO
, V
for regulated voltage range . . . . . . . . . . . . . . . . . . . . . . . 2.5 V to 2.75 V
Supply Voltages
Supply Voltages
Waveform
IO
(with the exception of CLK) (Note 1) . . . . . . . . . . . . . –0.5 V to 2.75 V
All other pins (Note 1) . . . . . . . . . . . . . . . . . . . . . . . –0.5 V to +2.75 V
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.65 V to 2.75 V
(Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –0.5 V to + 3.0 V
SS
20 ns
to –2.0 V for periods of up to 20 ns. See Figure 8. Maximum DC input voltage on pin
20 ns
A
A
) . . . . . . . . . . . . . . . . . . . . . . . . . –40°C to +85°C
) . . . . . . . . . . . . . . . . . . . . . . . . –40°C to +125°C
CC
A d v a n c e
+ 2.0 V for periods up to 20 ns. See Figure 9.
S29CD016G
Figure 9. Maximum Positive Overshoot Waveform
+2.0 V
+0.5 V
2.0 V
V
V
I n f o r m a t i o n
CC
CC
20 ns
20 ns
S29CD016_00A0 March 22, 2004
20 ns
SS