USB3280 SMSC Corporation, USB3280 Datasheet - Page 38

• Manufacturer Part Number: USB3280
• Description: Hi-Speed USB Device PHY
• Manufacturer: SMSC Corporation

Revision 1.2 (10-27-06)
8.11
PARAMETER
TIMING
T0
T1
T2
T3
T4
Assertion of Resume
In this case, an event internal to the device initiates the resume process. A device with remote wake-
up capability must wait for at least 5ms after the bus is in the idle state before sending the remote
wake-up resume signaling. This allows the hubs to get into their suspend state and prepare for
propagating resume signaling.
The device has 10ms where it can draw a non-suspend current before it must drive resume signaling.
At the beginning of this period the SIE may negate SUSPENDN, allowing the transceiver (and its
oscillator) to power up and stabilize.
Figure 8.7
device that was previously in FS mode would maintain TERMSELECT and XCVRSELECT high.
To generate resume signaling (FS 'K') the device is placed in the "Disable Bit Stuffing and NRZI
encoding" Operational Mode (OPMODE [1:0] = 10), TERMSELECT and XCVRSELECT must be in FS
mode, TXVALID asserted, and all 0's data is presented on the DATA bus for at least 1ms (T1 - T2).
Internal device event initiating the resume
process
Device asserts FS 'K' on the bus to signal
resume request to downstream port
The device releases FS 'K' on the bus. However
by this time the 'K' state is held by downstream
port.
Downstream port asserts SE0.
Latest time at which a device, which was
previously in HS mode, must restore HS mode
after bus activity stops.
illustrates the behavior of a device returning to HS mode after being suspended. At T4, a
Figure 8.7 Resume Timing Behavior (HS Mode)
Table 8.9 Resume Timing Values (HS Mode)
DESCRIPTION
DATASHEET
38
0 (reference)
T0 < T1 < T0 + 10ms.
T1 + 1.0ms < T2 < T1 + 15ms
T1 + 20ms
T3 + 1.33µs {2 Low-speed bit times}
Hi-Speed USB Device PHY with UTMI Interface
VALUE
SMSC USB3280
Datasheet