PIC10F200 Microchip Technology, Inc., PIC10F200 Datasheet - Page 23

• Manufacturer Part Number: PIC10F200
• Description: 6-Pin, 8-Bit Flash Microcontrollersfeatures 6-pin SOT-23 Packaging Precision 4 MHZ Internal Oscillator Baseline Core With 33 Instructions, 2 Stack Levels All Single-cycle Instructions Except For Program Branches Which Are Two Cycles 12-bit Wide
• Manufacturer: Microchip Technology, Inc.

4.6
The Oscillator Calibration (OSCCAL) register is used to
calibrate the internal precision 4 MHz oscillator. It
contains seven bits for calibration
After you move in the calibration constant, do not
change the value. See Section 9.2.2 “Internal 4 MHz
Oscillator”.
REGISTER 4-3:
 2004 Microchip Technology Inc.
Note:
OSCCAL Register
bit 7-1
bit 0
Erasing the device will also erase the pre-
programmed internal calibration value for
the internal oscillator. The calibration
value must be read prior to erasing the
part so it can be reprogrammed correctly
later.
OSCCAL REGISTER (ADDRESS: 05h)
CAL<6:0>: Oscillator Calibration bits
0111111 = Maximum frequency
•
•
•
0000001
0000000 = Center frequency
1111111
•
•
•
1000000 = Minimum frequency
FOSC4: INTOSC/4 Output Enable bit
1 = INTOSC/4 output onto GP2
0 = GP2/T0CKI/COUT applied to GP2
Legend:
R = Readable bit
-n = Value at POR
bit 7
R/W-1
Note 1: Overrides GP2/T0CKI/COUT control registers when enabled.
CAL6
.
R/W-1
CAL5
R/W-1
CAL4
Preliminary
W = Writable bit
‘1’ = Bit is set
PIC10F200/202/204/206
R/W-1
CAL3
(1)
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
R/W-1
CAL2
R/W-1
CAL1
x = Bit is unknown
R/W-1
CAL0
DS41239A-page 21
FOSC4
R/W-0
bit 0