ST7577 Sitronix Technology, ST7577 Datasheet - Page 14

• Manufacturer Part Number: ST7577
• Description: Dot Matrix LCD Controller/Driver
• Manufacturer: Sitronix Technology

ST7577
Data Transfer
ST7577 uses bus holder and internal data bus for data transfer with the MPU. When writing data from the MPU to on-chip
RAM, data is automatically transferred from the bus holder to the RAM as shown in Figure 4. And when reading data from
on-chip RAM to the MPU, the data for the initial read cycle is stored in the bus holder (dummy read) and the MPU reads this
stored data from bus holder for the next data read cycle as shown in Figure 5. This means that a dummy read cycle must be
inserted between each pair of address sets when a sequence of address sets is executed. Therefore, the data of the
specified address cannot be output with the read display data instruction right after the address sets, but can be output at
the second read of data.
Ver 1.0a
COLUMN ADDRESS
COLUMN ADDRESS
BUS HOLDER
BUS HOLDER
D0 to D7
Internal signals
D0 to D7
Internal signals
MPU signal
/W R
/W R
MPU signal
/RD
/RD
/WR
/WR
A0
A0
Figure 4
Figure 5
N
N
14/48
N
N
Write Timing
Read Timing
N
D(N)
D(N)
N
Dummy
N+1
D(N+1) D(N+2)
D(N+1)
D(N)
D(N)
D(N)
N+2
D(N+2)
D(N+1)
D(N+1)
D(N+1)
N+3
D(N+3)
D(N+3)
D(N+2)
D(N+2)
www.DataSheet4U.com
2008/02/14