ds2143qn-t-r Maxim Integrated Products, Inc., ds2143qn-t-r Datasheet - Page 9

• Manufacturer Part Number: ds2143qn-t-r
• Description: Ds2143, Ds2143q E1 Controller
• Manufacturer: Maxim Integrated Products, Inc.

RCR1: RECEIVE CONTROL REGISTER 1 (Address=10 Hex)
(MSB)
RSMF
SYMBOL
RESYNC
SYNCE
RSMF
RSIO
RSM
FRC
-
-
RSM
POSITION
RCR1.7
RCR1.6
RCR1.5
RCR1.4
RCR1.3
RCR1.2
RCR1.1
RCR1.0
RSIO
NAME AND DESCRIPTION
RSYNC Multiframe Function. Only used if the RSYNC pin is
programmed in the multiframe mode (RCR1.6=1).
0 = RSYNC outputs CAS multiframe boundaries
1 = RSYNC outputs CRC4 multiframe boundaries
RSYNC Mode Select.
0 = frame mode (see the timing in Section 13)
1 = multiframe mode (see the timing in Section 13)
RSYNC I/O Select.
0 = RSYNC is an output (depends on RCR1.6)
1 = RSYNC is an input (only valid if elastic store enabled)
(note: this bit must be set to 0 when RCR2.1=0)
Not Assigned. Should be set to 0 when written to.
Not Assigned. Should be set to 0 when written to.
Frame Resync Criteria.
0 = resync if FAS received in error 3 consecutive times
1 = resync if FAS or bit 2 of non-FAS is received in error 3
consecutive times
Sync Enable.
0 = auto resync enabled
1 = auto resync disabled
Resync. When toggled from low to high, a resync is initiated.
Must be cleared and set again for a subsequent resync.
-
9 of 44
-
FRC
SYNCE
DS2143/DS2143Q
RESYNC
(LSB)