upd78f0114m6gb-8es Renesas Electronics Corporation., upd78f0114m6gb-8es Datasheet - Page 258

• Manufacturer Part Number: upd78f0114m6gb-8es
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

258
1. Stop bit length: 1
2. Stop bit length: 2
(c) Transmission
The T
register 0 (ASIM0) is set to 1.
Transmission can be started by writing transmit data to transmit shift register 0 (TXS0). The start bit, parity
bit, and stop bit are automatically appended to the data.
When transmission is started, the start bit is output from the T
order starting from the LSB. When transmission is completed, the parity and stop bits set by ASIM0 are
appended and a transmission completion interrupt request (INTST0) is generated.
Transmission is stopped until the data to be transmitted next is written to TXS0.
Figure 12-8 shows the timing of the transmission completion interrupt request (INTST0). This interrupt
occurs as soon as the last stop bit has been output.
Caution After transmit data is written to TXS0, do not write the next transmit data before the
T
T
X
X
D0 (output)
D0 (output)
X
INTST0
INTST0
D0 pin outputs a high level when bit 7 (POWER0) of asynchronous serial interface operation mode
transmission completion interrupt signal (INTST0) is generated.
Figure 12-8. Transmission Completion Interrupt Request Timing
Start
Start
CHAPTER 12 SERIAL INTERFACE UART0
D0
D0
If bit 6 (TXE0) of ASIM0 is then set to 1, transmission is enabled.
User’s Manual U16227EJ3V0UD
D1
D1
D2
D2
D6
D6
X
D0 pin, followed by the rest of the data in
D7
D7
Parity
Parity
Stop
Stop