cy8c26233-24sxit Cypress Semiconductor Corporation., cy8c26233-24sxit Datasheet - Page 122

• Manufacturer Part Number: cy8c26233-24sxit
• Description: 8-bit Programmable System-on-chip Psoc? Microcontrollers
• Manufacturer: Cypress Semiconductor Corporation.

11.10.2.6
The device checksum is retrieved from the device and
compared to the “Device Checksum” from the user’s file
(Note that this is NOT the same thing as the “Record
Checksum.”) The checksum is retrieved from the device
with the following sequence:
CHECKSUM-SETUP(max_data_block)
WAIT-AND-POLL
READ-CHECKSUM(data)
11.11 Programming Wave Forms
Notes :
11.12 Programming File Format
The programming file is created by PSoC Designer, the
Cypress MicroSystems development tool. This tool gen-
erates the programming file in an Intel Hex format.
The programmer should assume the data is 30h/HALT if
it is not specified in the user’s data file.
122
SDATA
1
2
3
SCLK
Vcc
Vcc is only turned off (0V) at the very beginning and the very end of the flow - not within the programming flow.
When the programmer puts the driver on SDATA in a High Z (floating) state, the SDATA pin will float to a low
due to an internal device pull down circuit.
SCLK is set to VILP during the power up and power down; at other times the SCLK is “free running.” The fre-
quency of the hardware’s SCLK signal must be known by the software because the value (entered in the num-
ber of MegaHertz multiplied by the number 5) must be passed into the device with the SET-CLK-FREQ()
mnemonic.
Device Checksum (at Low Vcc and High Vcc)
OUT
Cypress MicroSystems CY8C25122/CY8C26233/CY8C26443/CY8C26643 Family Data Sheet
Document #: 38-12010 CY Rev. ** CMS Rev. 3.20
OUT
Figure 33: Programming Wave Forms
IN
Tssclk
Thsclk
Note : This should be done 2 times; once at Vcc=Vcchv
and once at Vcc=Vcclv.
11.10.2.7
The last step is to power down the device. This is
accomplished by the following sequence:
Set SDATA=HighZ (float pin P1[0])
Set SCLK=0V (Vin on pin P1[1]=Vilp)
Set Vcc = 0V
Power Down
IN
September 5, 2002