mpc89l515ap Megawin Technology, mpc89l515ap Datasheet - Page 25

• Manufacturer Part Number: mpc89l515ap
• Description: 8-bit Micro-controller
• Manufacturer: Megawin Technology

SM2: Enable the automatic address recognition feature in mode 2 and 3. If SM2=1, RI will not be set unless the
For another example:
REN: Enable the serial port reception. 1 := enable
TB8: The 9th data bit, which will be transmitted in Mode 2 and Mode 3.
RB8: In mode 2 and 3, the received 9th data bit will go into this bit.
TI: Transmit interrupt flag. After a transmit has been finished, the hardware will set this bit.
RI: Receive interrupt flag. After reception has been finished, the hardware will set this bit.
SFR: SBUF (Serial port Buffer register):
Automatic Address Recognition
There is an extra feature makes the device convenient to act as a master, which communicates to
multiple slaves simultaneously. It is really Automatic Address Recognition.
There are two SFR SADDR and SADEN implemented in the device. The user can read or write
both of them. Finally, the hardware will make use of these two SFR to “generate” a “compared byte”.
The formula specifies as following.
For example:
After the generic “Compared Byte” has been worked out, the MPC89x515A will make use of this byte to
determine how to set the bit RI in SFR SCON.
Normally, an UART will set bit RI whenever it has done a byte reception; but for the UART in the
MPC89x515A, if the bit SM2 is set, it will set RI according to the following formula.
MEGAWIN
Bit-7
received 9th data bit is 1, indicating an address, and the received byte is a Given or Broadcast address.
In mode1, if SM2=1 then RI will not be set unless a valid stop Bit was received, and the received byte is
a Given or Broadcast address.
Bit[ i ] of Compared Byte = (SADEN[ i ] == 1 )? SADDR[ i ] : x
RI = (SM2 == 1) && (SBUF == Compared Byte) && (RB8 == 1)
Set SADDR = 11000000b
Set SADEN = 11111101b
Set SADDR = 11100000b
Set SADEN = 11111010b
The achieved “Compared Byte” will be “110000x0”
The achieved “Compared Byte” will be “11100x0x”
Bit-6
(data to be transmitted or received data)
Bit-5
MPC89x515A Data Sheet
Bit-4
Bit-3
0 := disable
Bit-2
(x means don’t care)
Bit-1
Bit-0
25