at89c51cc03c-slsim ATMEL Corporation, at89c51cc03c-slsim Datasheet - Page 146

• Manufacturer Part Number: at89c51cc03c-slsim
• Description: At89c51cc03 Enhanced 8-bit Mcu With Can Controller And Flash Memory
• Manufacturer: ATMEL Corporation

Figure 72. PCA PWM Mode
PCA WatchDog Timer
146
AT89C51CC03
CL rolls over from FFh TO 00h loads
CCAPnH contents into CCAPnL
CL (8 bits)
An on-board WatchDog timer is available with the PCA to improve system reliability
without increasing chip count. WatchDog timers are useful for systems that are sensitive
to noise, power glitches, or electrostatic discharge. Module 4 is the only PCA module
that can be programmed as a WatchDog. However, this module can still be used for
other modes if the WatchDog is not needed. The user pre-loads a 16-bit value in the
compare registers. Just like the other compare modes, this 16-bit value is compared to
the PCA timer value. If a match is allowed to occur, an internal reset will be generated.
This will not cause the RST pin to be driven high.
To hold off the reset, the user has three options:
•
•
•
The first two options are more reliable because the WatchDog timer is never disabled as
in the third option. If the program counter ever goes astray, a match will eventually occur
and cause an internal reset. If other PCA modules are being used the second option not
recommended either. Remember, the PCA timer is the time base for all modules;
changing the time base for other modules would not be a good idea. Thus, in most appli-
cations the first solution is the best option.
periodically change the compare value so it will never match the PCA timer,
periodically change the PCA timer value so it will never match the compare values,
or
disable the WatchDog by clearing the WDTE bit before a match occurs and then re-
enable it.
CCAPMn.6
ECOMn
8-Bit
Comparator
CCAPnL
CCAPnH
CCAPMn.1
PWMn
CL > = CCAPnL
CL < CCAPnL
“0”
“1”
4182N–CAN–03/08
CEX