at24c256c ATMEL Corporation, at24c256c Datasheet - Page 3

• Manufacturer Part Number: at24c256c
• Description: Two-wire Serial Eeprom
• Manufacturer: ATMEL Corporation

1.
8568A–SEEPR–11/08
Pin Descriptions
SERIAL CLOCK (SCL): The SCL input is used to positive-edge clock data into each EEPROM device and
negative-edge clock data out of each device.
SERIAL DATA (SDA): The SDA pin is bidirectional for serial data transfer. This pin is open drain driven and may be
wire-ORed with any number of other open-drain or open-collector devices.
DEVICE/PAGE ADDRESSES (A2, A1, A0): The A2, A1, and A0 pins are device address inputs that are hardwired
(directly to GND or to V
eight 256K devices may be addressed on a single bus system. (Device addressing is discussed in detail under
Addressing”) A device is selected when a corresponding hardware and software match is true. If these pins are left
floating, the A2, A1, and A0 pins will be internally pulled down to GND. However, due to capacitive coupling that may
appear during customer applications, Atmel recommends always connecting the address pins to a known state. When
using a pull-up resistor, Atmel recommends using 10kΩ or less.
WRITE PROTECT (WP): The write protect input, when connected to GND, allows normal write operations. When WP
is connected directly to V
internally pulled down to GND. However, due to capacitive coupling that may appear during customer applications,
Atmel recommends always connecting the WP pins to a known state. When using a pull-up resistor, Atmel
recommends using 10kΩ or less.
CC
CC
) for compatibility with other AT24Cxx devices. When the pins are hardwired, as many as
, all write operations to the memory are inhibited. If the pin is left floating, the WP pin will be
AT24C256C [Preliminary]
“Device
3