w29ee011 Winbond Electronics Corp America, w29ee011 Datasheet - Page 4

• Manufacturer Part Number: w29ee011
• Description: 128k X 8 Cmos Flash Memory
• Manufacturer: Winbond Electronics Corp America

Hardware Data Protection
The integrity of the data stored in the W29EE011 is also hardware protected in the following ways:
(1) Noise/Glitch Protection: A WE pulse of less than 15 nS in duration will not initiate a write cycle.
(2) V
(3) Write Inhibit Mode: Forcing OE low, CE high, or WE high will inhibit the write operation. This
Data Polling (DQ
The W29EE011 includes a data polling feature to indicate the end of a programming cycle. When the
W29EE011 is in the internal programming cycle, any attempt to read DQ
during the page/byte-load cycle will receive the complement of the true data. Once the programming
cycle is completed. DQ
Toggle Bit (DQ
In addition to data polling, the W29EE011 provides another method for determining the end of a
program cycle. During the internal programming cycle, any consecutive attempts to read DQ
produce alternating 0's and 1's. When the programming cycle is completed, this toggling between 0's
and 1's will stop. The device is then ready for the next operation.
5-Volt-only Software Chip Erase
The chip-erase mode can be initiated by a six-byte command sequence. After the command loading
cycles, the device enters the internal chip erase mode, which is automatically timed and will be
completed in 50 mS. The host system is not required to provide any control or timing during this
operation.
Product Identification
The product ID operation outputs the manufacturer code and device code. Programming equipment
automatically matches the device with its proper erase and programming algorithms.
The manufacturer and device codes can be accessed by software or hardware operation. In the
software access mode, a six-byte command sequence can be used to access the product ID. A read
from address 0000H outputs the manufacturer code (DAh). A read from address 0001H outputs the
device code (C1h). The product ID operation can be terminated by a three-byte command sequence.
In the hardware access mode, access to the product ID is activated by forcing CE and OE low, WE
high, and raising A9 to 12 volts.
3.8V.
prevents inadvertent writes during power-up or power-down periods.
DD
Power Up/Down Detection: The programming operation is inhibited when V
6
)-Write Status Detection
7
)-Write Status Detection
7
will show the true data.
- 4 -
7
of the last byte loaded
W29EE011
DD
is less than
6
will