pic32mx320f032h Microchip Technology Inc., pic32mx320f032h Datasheet - Page 3

• Manufacturer Part Number: pic32mx320f032h
• Description: 64/100-pin General Purpose And Usb 32-bit Flash Microcontrollers
• Manufacturer: Microchip Technology Inc.

High-Performance 32-bit RISC CPU:
• MIPS32
• 80 MHz Maximum Frequency
• 1.56 DMIPS/MHz (Dhrystone 2.1) Performance
• Single-Cycle Multiply and High-Performance
• MIPS16e™ Mode for Up to 40% Smaller Code
• Two Sets of 32 Core Register Files (32-bit) to
• Prefetch Cache Module to Speed Execution from
Microcontroller Features:
• Operating Voltage Range of 2.3V to 3.6V
• 32K to 512K Flash Memory (plus an additional
• 8K to 32K SRAM Memory
• Pin-Compatible with Most PIC24/dsPIC
• Multiple Power Management Modes
• Multiple Interrupt Vectors with Individually
• Fail-Safe Clock Monitor Mode
• Configurable Watchdog Timer with On-Chip
Peripheral Features:
• Atomic SET, CLEAR and INVERT Operation on
• Up to 4-Channel Hardware DMA with Automatic
• USB 2.0 Compliant Full Speed Device and
• USB has a Dedicated DMA Channel
• 10 MHz to 40 MHz Crystal Oscillator
• Internal 8 MHz and 32 kHz Oscillators
© 2009 Microchip Technology Inc.
at 0 Wait State Flash Access
Divide Unit
Size
Reduce Interrupt Latency
Flash
12KB of Boot Flash)
Programmable Priority
Low-Power RC Oscillator for Reliable Operation
Select Peripheral Registers
Data Size Detection
On-The-Go (OTG) Controller
High-Performance 80 MHz MIPS-Based 32-bit Flash Microcontroller
®
M4K™ 32-bit Core with 5-Stage Pipeline
64/100-Pin General Purpose and USB
®
Devices
Preliminary
PIC32MX3XX/4XX
• Separate PLLs for CPU and USB Clocks
• Two I
• Two UART Modules with:
• Parallel Master and Slave Port (PMP/PSP) with
• Hardware Real-Time Clock/Calendar (RTCC)
• Five 16-bit Timers/Counters (two 16-bit pairs com-
• Five Capture Inputs
• Five Compare/PWM Outputs
• Five External Interrupt Pins
• High-Speed I/O Pins Capable of Toggling at Up to
• High-Current Sink/Source (18 mA/18 mA) on
• Configurable Open-Drain Output on Digital I/O
Debug Features:
• Two Programming and Debugging Interfaces:
• Unintrusive Hardware-Based Instruction Trace
• IEEE Std 1149.2 Compatible (JTAG) Boundary
Analog Features:
• Up to 16-Channel 10-bit Analog-to-Digital
• Two Analog Comparators
• 5V Tolerant Input Pins (digital pins only)
- RS-232, RS-485 and LIN 1.2 support
- IrDA
8-bit and 16-bit Data and Up to 16 Address Lines
bine to create two 32-bit timers)
80 MHz
All I/O Pins
Pins
- 2-Wire Interface with Unintrusive Access and
- 4-wire MIPS
Scan
Converter:
- 1000 ksps Conversion Rate
- Conversion Available During Sleep, Idle
Decoder
Real-time Data Exchange with Application
interface
2
C™ Modules
®
with On-Chip Hardware Encoder and
®
Standard Enhanced JTAG
DS61143F-page 1