p89lpc9171fdh NXP Semiconductors, p89lpc9171fdh Datasheet - Page 56

• Manufacturer Part Number: p89lpc9171fdh
• Description: 8-bit Microcontroller With Accelerated Two-clock 80c51 Core, 2 Kb 3 V Byte-erasable Flash With 8-bit Adc
• Manufacturer: NXP Semiconductors

NXP Semiconductors
P89LPC9151_61_71_2
Product data sheet
Fig 19. Comparator input and output connections
(P0.5) CMPREF
7.24.1 Internal reference voltage
7.24.2 Comparator interrupt
7.24.3 Comparators and power reduction modes
(P0.4) CIN1A
(P0.3) CIN1B
(P0.2) CIN2A
(P0.1) CIN2B
V
ref(bg)
An internal reference voltage generator may supply a default reference when a single
comparator input pin is used. The value of the internal reference voltage, referred to as
V
Each comparator has an interrupt flag contained in its configuration register. This flag is
set whenever the comparator output changes state. The flag may be polled by software or
may be used to generate an interrupt. The two comparators use one common interrupt
vector. If both comparators enable interrupts, after entering the interrupt service routine,
the user needs to read the flags to determine which comparator caused the interrupt.
Either or both comparators may remain enabled when Power-down or Idle mode is
activated, but both comparators are disabled automatically in Total Power-down mode.
If a comparator interrupt is enabled (except in Total Power-down mode), a change of the
comparator output state will generate an interrupt and wake-up the processor. If the
comparator output to a pin is enabled, the pin should be configured in the push-pull mode
in order to obtain fast switching times while in Power-down mode. The reason is that with
the oscillator stopped, the temporary strong pull-up that normally occurs during switching
on a quasi-bidirectional port pin does not take place.
Comparators consume power in Power-down and Idle modes, as well as in the normal
operating mode. This fact should be taken into account when system power consumption
is an issue. To minimize power consumption, the user can disable the comparators via
PCONA.5, or put the device in Total Power-down mode.
ref(bg)
, is 1.23 V ± 10 %.
CN1
CN2
CP1
CP2
comparator 1
comparator 2
Rev. 02 — 9 February 2010
CO1
CO2
change detect
change detect
OE1
OE2
P89LPC9151/9161/9171
CMF1
CMF2
8-bit microcontroller with 8-bit ADC
CMP1 (P0.6)
CMP2 (P0.0)
EC
002aae433
interrupt
© NXP B.V. 2010. All rights reserved.
56 of 91