ak4342 AKM Semiconductor, Inc., ak4342 Datasheet - Page 24

• Manufacturer Part Number: ak4342
• Description: 24-bit Stereo Dac With Hp-amp & 2v Line-out
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
Power supply voltage for lineout amplifier is applied from HVDD and HVEE pins. HVEE pin must be connected with
PVEE pin directly. PVEE pin outputs the negative voltage generated by the internal charge pump circuit. The lineout
amplifiers are single-ended outputs and centered on 0V(HVSS). The output level is typically 2Vrms (@ AVDD=3.3V,
0dBFS). The minimum load resistance is 10kΩ.
1. Analog volume for lineout
These volumes are common to L/R channels and can attenuate the DAC output signal from +0dB to –31dB with 1dB step
(See Table 11). Changing levels don’t have any pop noise. The transition time is selected by PTS1-0 bits and sampling
frequency (See Table 2 and Table 15).
2. Mute Function
When LMUTE bit is set to “1”, the lineout amplifiers (LOUT and ROUT pins) go to ground level (0V). This mute time
depends on the setting of PTS1-0 bits and sampling frequency(FS3-0 bits). This function is common to L/R channels.
When LMUTE bit is set to “0”, the outputs are in normal operation.
3. Power-up/down
Lineout amplifiers are powered-up/down by PMLO bit. The power-on/off time depends on the setting of PUT1-0 bits and
sampling frequency (FS3-0 bits). The power-up/down of lineout amplifiers should be done in the mute state (LMUTE bit
= “1”).
4. Output circuit
When LOUT/ROUT drives some capacitive load, a resistor should be added in series between LOUT/ROUT and
capacitive load. Figure 18 shows an example of 470Ω series resistor. In this case, LOUT/ROUT can drive capacitive load
up to 1nF.
MS0506-E-02
Lineout amp
LOUT/ROUT
LPGA4-0 bits
1DH
1CH
1FH
1EH
18H
01H
00H
•
Figure 18. External 1
(fc = 339kHz, gain = -0.06dB @ 40kHz)
Table 11. Volume Setting for Lineout
ATT (dB)
-29
-30
-31
-1
-2
-3
0
•
st
470
order LPF Circuit Example
- 24 -
1n
Step
1dB
Level
32
Analog
Out
Default
[AK4342]
2006/07