xr16m780 Exar Corporation, xr16m780 Datasheet - Page 38

• Manufacturer Part Number: xr16m780
• Description: 1.62v To 3.63v High Performance Uart With 64-byte Fifo
• Manufacturer: Exar Corporation

XR16M780
1.62V TO 3.63V HIGH PERFORMANCE UART WITH 64-BYTE FIFO
This register replaces SPR (during a Write) and is accessible only when FCTR[6] = 1.
EMSR[1:0]: Receive/Transmit FIFO Level Count
When Scratchpad Swap (FCTR[6]) is asserted, EMSR bits 1-0 controls what mode the FIFO Level Counter is
operating in.
During Alternate RX/TX FIFO Level Counter Mode, the first value read after EMSR bits 1-0 have been
asserted will always be the RX FIFO Level Counter. The second value read will correspond with the TX FIFO
Level Counter. The next value will be the RX FIFO Level Counter again, then the TX FIFO Level Counter and
so on and so forth.
EMSR[2]: Send TX Immediately
•
•
EMSR[3]: Invert RTS in RS485 mode
•
•
4.12
Logic 0 = Do not send TX immediately (default).
Logic 1 = Send TX immediately. When FIFO is enabled and this bit is set, the next data will be written to the
TX shift register. Thus, the data will be sent out immediately instead of queuing in the FIFO. Every time, only
1 byte will be send out. Once this byte has been sent out, the EMSR[2] will go back to 0 automatically. If
more than 1 byte will be sent out, EMSR[2] needs to be set to 1 for each byte.
Logic 0 = RTS# output is a logic 0 during TX and a logic 1 during RX (default).
Logic 1 = RTS# output is a logic 1 during TX and a logic 0 during RX.
Enhanced Mode Select Register (EMSR) - Write-only
FCTR[6] EMSR[1] EMSR[0] Scratchpad is
0
1
1
1
X
X
0
1
T
ABLE
12: S
X
0
1
1
CRATCHPAD
Scratchpad
RX FIFO Level Counter Mode
TX FIFO Level Counter Mode
Alternate RX/TX FIFO Counter Mode
38
S
WAP
S
ELECTION
REV. 1.0.0