ia186eb Innovasic Semiconductor Inc., ia186eb Datasheet - Page 58

• Manufacturer Part Number: ia186eb
• Description: 8-bit/16-bit Microcontrollers
• Manufacturer: Innovasic Semiconductor Inc.

IA186EB/IA188EB
8-Bit/16-Bit Microcontrollers
6.
The IA186EB/IA188EB will perform a reset operation any time the resin_n pin is active.
Figure 20 shows the reset sequence when power is applied to the IA186EB/IA188EB. An
external clock connected to clkin must not exceed the V
processor. This is normally not a problem if the clock driver is supplied with the same V
supplies the processor. When attaching a crystal to the device, resin_n must remain active until
both V
startup characteristics of the crystal circuit). The resin_n pin is designed to operate correctly
using an RC reset circuit, but the designer must ensure that the ramp time for V
that resin_n is never really sampled at a logic low level when V
conditions.
Note: Failure to assert resin_n while the device is powering up will result in unpredictable
operation.
Figure 21, Warm Reset Timing, shows the timing sequence when resin_n is applied after V
stable and the device has been operating. Any bus operation that is in progress at the time
resin_n is asserted will terminate immediately.
While resin_n is active, bus signals lock_n, a19/once_n, and a18–a16 are configured as inputs
and weakly held high by internal pull-up transistors. Only a19/ once_n can be overdriven to a
low-to-enable ONCE Mode.
CC
Reset Operation
and clkout are stable (the length of time is application-specific and depends on the
®
UNCONTROLLED WHEN PRINTED OR COPIED
Page 58 of 82
IA211080314-02
CC
threshold being applied to the
CC
reaches minimum operating
http://www.Innovasic.com
CC
January 14, 2009
is not so long
Customer Support:
Data Sheet
1-888-824-4184
CC
cc
that
is