ic42s16400 ETC-unknow, ic42s16400 Datasheet - Page 20

• Manufacturer Part Number: ic42s16400
• Description: 1m X 16bit X 4 Banks 64-mbit Sdram
• Manufacturer: ETC-unknow

IC42S16400
Auto Precharge
During a read or write command cycle, A10 controls whether auto precharge is selected. If A10 is high in the read or write
command (Read with Auto precharge command or Write with Auto precharge command), auto precharge is selected and
begins automatically.
In the write cycle, t
When using auto precharge in the read cycle, knowing when the precharge starts is important because the next activate
command to the bank being precharged cannot be executed until the precharge cycle ends. Once auto precharge has
started, an activate command to the bank can be asserted after t
A Read or Write command without auto - precharge can be terminated in the midst of a burst operation. However, a Read
or Write command with auto - precharge can not be interrupted by the same bank commands before the entire burst opera-
tion is completed. Therefore use of the same bank Read, Write, Precharge or Burst Stop command is prohibited during a
read or write cycle with auto - precharge. It should be noted that the device will not respond to the Auto - Precharge com-
mand if the device is programmed for full page burst read or write cycles.
The timing when the auto precharge cycle begins depends both on both the CAS Iatency programmed into the mode reg-
ister and whether the cycle is read or write.
Read with Auto Precharge
During a READA cycle, the auto precharge begins one clock earlier (CL = 2) or two clocks earlier (CL = 3) than the last word
output.
READ with AUTO PRECHARGE
20
Remark READA means READ with AUTO PRECHARGE
CAS latency = 2
CLK
Command
DQ
Command
CAS latency = 3
DQ
DAL
(min.) must be satisfied before asserting the next activate command to the bank being precharged.
T0
READA B
READA B
T1
No New Command to Bank B
T2
No New Command to Bank B
QB0
T3
RP
QB0
QB1
has been satisfied.
Auto precharge starts
Auto precharge starts
T4
QB1
QB2
T5
QB2
Integrated Circuit Solution Inc.
QB3
T6
QB3
Hi - Z
T7
Burst lengh = 4
Hi - Z
DR034-0E 12/02/2003
T8