88e3016 Marvell Semiconductor, Inc., 88e3016 Datasheet - Page 39
![no-image](/images/no-image-200.jpg)
88e3016
Manufacturer Part Number
88e3016
Description
Integrated 10/100 Fast Ethernet Transceiver
Manufacturer
Marvell Semiconductor, Inc.
Datasheet
1.88E3016.pdf
(106 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
88e3016-A1-NNC1C000
Manufacturer:
MARVELL
Quantity:
20 000
Company:
Part Number:
88e3016-A2-NNC1C
Manufacturer:
MARVELL
Quantity:
537
2.12 Automatic and Manual Impedance Calibration
2.12.1 MAC Interface Calibration Circuit
The auto calibration is available for the MAC interface I/Os. The PHY runs the automatic calibration circuit with a
49 ohm impedance target by default after hardware reset. Other impedance targets are available by changing the
impedance target and restarting the auto calibration through register writes. Individual NMOS and PMOS output
transistors could be controlled for 38 to 80 ohm targets in various increments.
Manual NMOS and PMOS settings are available if the automatic calibration is not desired. If the PCB traces are
different from 50 ohms, the output impedance of the MAC interface I/O buffers can be programmed to match the
trace impedance. Users can adjust the NMOS and PMOS driver output strengths to perfectly match the transmis-
sion line impedance and eliminate reflections completely.
2.12.2 MAC Interface Calibration Register Definitions
If Register 29 = 0x000A, then Register 30 is defined as follows:
Table 24:
Copyright © 2006 Marvell
May 4, 2006, Advance
R e g
b it
15
14
13
12:8
7
6
F u n c t i o n
Restart Calibration
Calibration Com-
plete
Reserved
PMOS Value
Reserved
Latch
Register 30 Page 10 - MAC Interface Calibration Definitions
Document Classification: Proprietary Information
S e t t i n g de s c r i p t io n
0 = Normal
1 = Restart
Bit 15 is a self-clearing register. Calibration
will start once the register is cleared.
1 = Calibration complete
0 = Calibration in progress
0
00000 = All fingers off
...
11111 = All fingers on
The automatic calibrated values are stored
here after calibration completes.
Once the LATCH bit is set to 1, the new cal-
ibration value is written. The automatic cali-
brated value is lost.
0
1 = Latch in new value. This bit self clears.
(Used for manual settings)
CONFIDENTIAL
Automatic and Manual Impedance Calibration
M od e
R/W
RO
R/W
R/W
R/W
R/W,
SC
Doc. No. MV-S103164-00, Rev. --
H W
R e s e t
0
0
0
Auto cal-
ibrated
value
0
0
S W
R e s e t
Retain
Retain
Retain
Retain
Retain
Retain
Page 39