STV-5410-R01 STMICROELECTRONICS [STMicroelectronics], STV-5410-R01 Datasheet - Page 68

• Manufacturer Part Number: STV-5410-R01
• Description: Mono and Colour Digital Video CMOS Image Sensors
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

VV5410 & VV6410
[18], [12] - sync_reset
[19], [13] - reserved
[20], [14] - fg_modes
Bits [3:2] of the fg_mode register are mode dependent. If the NTSC or PAL video modes are selected then the free running QCK
mode will be selected. The slow QCK is selected by default, regardless of the video mode.
note1: The FST pin will always output the free running version of QCK (either inverted or normal)
68/105
7:0
1:0
3:2
5:4
7:6
Bit
Bit
Bit
5
6
7
Pixel counter reset value
FST/QCK pin modes
QCK modes
LST modes
FST modes
Enable additional black lines (lines 3-8)
Off/On
reserved
Pixel read-out order (hshuffle)
Unshuffled or Shuffled
0
0
1
1
fg_mode[1:0]
Function
Function
Function
Commercial in confidence
0
1
0
1
Table 33 : FST/QCK Pin Selection
Table 31 : [18], [12] - sync_reset
cd5410-6410f-3-0.fm
Table 32 : [20], [14] - fg_modes
Table 30 : [17], [11] - Setup1
Default
Default
Invert of Fast QCK
Default
31
00
00
00
00
0
1
1
Fast QCK
FST pin
FST
FST
During synchronisation the pixel counter can be
reset to the known value or offset by up to 255
pck’s into the pixel count sequence.
Selection of FST, QCK pin data
00 - if CIF & QCIF mode selected
01 - if NTSC and PAL mode selected
See Table 35 below for details
See Table 36 below for details
If enabled this bit will also enable the lines
immediately following the end of frame line. This
bit can only set/reset if the VP3 mode (ON) has
been selected. In VP3 mode (OFF) operation all
possible black lines are always output.
It is strongly recommended to use shuffled
horizontal read-out with VV6410 sensor.
note1
note1
Comment
Comment
Comment
QCK pin
Slow QCK
Slow QCK
Fast QCK
Fast QCK
Serial Control Bus