PCF8563BS NXP [NXP Semiconductors], PCF8563BS Datasheet - Page 4

• Manufacturer Part Number: PCF8563BS
• Description: Real-time clock/calendar
• Manufacturer: NXP [NXP Semiconductors]

NXP Semiconductors
7. Functional description
PCF8563_6
Product data sheet
6.2 Pin description
7.1 Alarm function modes
Table 2.
The PCF8563 contains sixteen 8-bit registers with an auto-incrementing address register,
an on-chip 32.768 kHz oscillator with one integrated capacitor, a frequency divider which
provides the source clock for the Real-Time Clock/calender (RTC), a programmable clock
output, a timer, an alarm, a voltage-low detector and a 400 kHz I
All 16 registers are designed as addressable 8-bit parallel registers although not all bits
are implemented. The first two registers (memory address 00h and 01h) are used as
control and/or status registers. The memory addresses 02h through 08h are used as
counters for the clock function (seconds up to years counters). Address locations 09h
through 0Ch contain alarm registers which define the conditions for an alarm.
Address 0Dh controls the CLKOUT output frequency. 0Eh and 0Fh are the timer control
and timer registers, respectively.
The seconds, minutes, hours, days, weekdays, months, years as well as the minute alarm,
hour alarm, day alarm and weekday alarm registers are all coded in Binary Coded
Decimal (BCD) format.
When one of the RTC registers is read the contents of all counters are frozen. Therefore,
faulty reading of the clock/calendar during a carry condition is prevented.
By clearing the MSB of one or more of the alarm registers (bit AE = Alarm Enable), the
corresponding alarm condition(s) will be active. In this way an alarm can be generated
from once per minute up to once per week. The alarm condition sets the Alarm Flag (AF).
The asserted AF can be used to generate an interrupt (on pin INT). The AF can only be
cleared by software.
Symbol
OSCI
OSCO
n.c.
INT
V
SDA
SCL
CLKOUT
V
n.c.
SS
DD
Pin description
Pin
DIP8, SO8, TSSOP8
1
2
-
3
4
5
6
7
8
-
Rev. 06 — 21 February 2008
HVSON10
1
2
3
4
5
6
7
8
9
10
Description
oscillator input
oscillator output
not connected
interrupt output (open-drain; active LOW)
ground
serial data input and output
serial clock input
clock output, open-drain
positive supply voltage
not connected
Real-time clock/calendar
2
C-bus interface.
PCF8563
© NXP B.V. 2008. All rights reserved.
4 of 32