MAX6884ETP MAXIM [Maxim Integrated Products], MAX6884ETP Datasheet - Page 10

• Manufacturer Part Number: MAX6884ETP
• Description: EEPROM-Programmable, Hex Power-Supply Supervisory Circuits
• Manufacturer: MAXIM [Maxim Integrated Products]

The MAX6884/MAX6885 feature a watchdog timer with
programmable initial and normal timeout periods from
6.25ms to 102.4s. WDO asserts when WDI is not tog-
gled from high-to-low or low-to-high within the appro-
priate watchdog timeout period. Program WDO to
assert RESET.
EEPROM-Programmable, Hex
Power-Supply Supervisory Circuits
Table
*ADC does not affect programmable outputs.
10
Input Voltages IN1–IN6
Programmable Output RESET
Programmable Output UV/OV
Programmable Output WDO
Watchdog Timer
V
Manual Reset Input MR
Reference Input REFIN
10-Bit ADC*
Write Disable
Configuration Lock
CC
______________________________________________________________________________________
Power Mode
1. Programmable Features
FEATURE
• Primary undervoltage threshold
• Secondary undervoltage or overvoltage threshold
• 1V to 5.8V thresholds in 20mV increments
• 0.5V to 3.05V thresholds in 10mV increments
• 0.1667V to 1.017V thresholds in 3.3mV increments in high-impedance mode
• Dependency on IN1–IN6, MR, UV/OV, and/or WDO
• Active-low, weak pullup, or open-drain output
• Programmable timeout periods of 25µs, 1.5625ms, 6.25ms, 25ms, 50ms, 200ms, 400ms, or
• Dependency on IN1–IN6, MR, and/or RESET
• Active-low, weak pullup, or open-drain output
• Programmable timeout periods of 25µs, 1.5625ms, 6.25ms, 25ms, 50ms, 200ms, 400ms, or
• Active-low, weak pullup, or open-drain output
• Initial watchdog timeout period of 6.25ms, 25ms, 100ms, 400ms, 1.6s, 6.4s, 25.6s, or 102.4s
• Normal watchdog timeout period of 6.25ms, 25ms, 100ms, 400ms, 1.6s, 6.4s, 25.6s, or 102.4s
• Watchdog enable/disable
• Programs whether the device is powered from the highest IN_ input or from an external supply
• Program RESET or UV/OV to assert while MR is asserted
• Internal +1.25V reference voltage
• Goes high impedance when internal reference is selected
• External reference voltage input from 1.225V to 1.275V
• Sets ADC voltage range
• Samples voltages at IN1–IN6, AUXIN, and V
• Completes conversion of all eight inputs in 200ms
• Reference voltage sets ADC range
• Read ADC data from SMBus/I
• Locks user EEPROM based on RESET or UV/OV assertion
• Locks configuration registers and EEPROM
1.6s
1.6s
connected to V
CC
2
C interface
Program the MAX6884/MAX6885 to receive power
through IN1–IN4 or V
MAX6884/MAX6885 section). Outputs remain asserted
while the voltage that is supplying the device is below
UVLO (2.5V) and above 1V (see
DESCRIPTION
CC
CC
(see the Powering the
Figure
1).