LUPA-1300 CYPRESS [Cypress Semiconductor], LUPA-1300 Datasheet - Page 43

• Manufacturer Part Number: LUPA-1300
• Description: 1.3 M Pixel High Speed CMOS Image Sensor
• Manufacturer: CYPRESS [Cypress Semiconductor]

LUPA-1300
Datasheet
Figure 24: Transmission characteristics of the S8612 glass used as NIR cut-off filter.
6.5 Handling and Storage precautions
6.6 Handling precautions
Special care should be given when soldering image sensors with color filter arrays
(RGB color filters), onto a circuit board, since color filters are sensitive to high
temperatures. Prolonged heating at elevated temperatures may result in deterioration
of the performance of the sensor. The following recommendations are made to ensure
that sensor performance is not compromised during end-users’ assembly processes.
Board Assembly:
Device placement onto boards should be done in accordance with strict ESD controls
for Class 0, JESD22 Human Body Model, and Class A, JESD22 Machine Model
devices. Assembly operators should always wear all designated and approved
grounding equipment; grounded wrist straps at ESD protected workstations are
recommended including the use of ionized blowers. All tools should be ESD
protected.
Manual Soldering:
When a soldering iron is used the following conditions should be observed:
Use a soldering iron with temperature control at the tip.
Cypress Semiconductor Corporation
3901 North First Street
San Jose, CA 95134
408-943-2600
Contact [e-mail]
Document # : 38-05711 Rev.**( Revision 3.1)
Page 43 of 48