HD6433045 HITACHI [Hitachi Semiconductor], HD6433045 Datasheet - Page 209

• Manufacturer Part Number: HD6433045
• Description: Hitachi Single-Chip Microcomputer
• Manufacturer: HITACHI [Hitachi Semiconductor]

Bit 3—Data Transfer Interrupt Enable (DTIE): Enables or disables the CPU interrupt (DEND)
requested when the DTE bit is cleared to 0.
Bit 3
DTIE
0
1
Bits 2 to 0—Data Transfer Select (DTS2, DTS1, DTS0): These bits select the data transfer
activation source. Some of the selectable sources differ between channels A and B.*
Note: * Refer to 8-3-4, Data Transfer Control Registers (DTCR).
Bit 2
DTS2
0
1
The same internal interrupt can be selected as an activation source for two or more channels at
once. In that case the channels are activated in a priority order, highest-priority channel first. For
the priority order, see section 8.4.9, Multiple-Channel Operation.
When a channel is enabled (DTE = 1), its selected DMAC activation source cannot generate a
CPU interrupt.
Description
The DEND interrupt requested by DTE is disabled
The DEND interrupt requested by DTE is enabled
Bit 1
DTS1
0
1
0
1
Bit 0
DTS0
0
1
0
1
0
1
0
1
Compare match/input capture A interrupt from ITU
Transmit-data-empty interrupt from SCI channel 0
Description
channel 0
Compare match/input capture A interrupt from ITU channel 1
Compare match/input capture A interrupt from ITU channel 2
Compare match/input capture A interrupt from ITU channel 3
Receive-data-full interrupt from SCI channel 0
Falling edge of
Transfer in full address mode (channel A)
Low level of DREQ input (channel B)
Transfer in full address mode (channel A)
DREQ input (channel B)
195
(Initial value)
(Initial value)