HD6433045 HITACHI [Hitachi Semiconductor], HD6433045 Datasheet - Page 584

• Manufacturer Part Number: HD6433045
• Description: Hitachi Single-Chip Microcomputer
• Manufacturer: HITACHI [Hitachi Semiconductor]

Bit 7—Programming Power (V
displayed as “1” or “0.” The permissible output currents for impressed high voltage VH are given
in 21.3.1, “DC Characteristics.” The value of VH ranges from V
excess of VH is applied, “1” is displayed; otherwise “0” is displayed.
This bit restricts the hardware protect functions during write and erase operations for the flash
memory. For details on hardware protect, see 18.7.8, “Protect Modes.” For notes on VPP usage,
see 10.10, “Flash Memory Programming and Erasing Precautions.”
Bit 7
V
0
1
Note: For correct write and erase functions, the setting should be V
Bit 6—V
set, it is necessary to wait for at least 5 µs for the internal power supply to stabilize; programming
and erasing cannot be performed until stabilization is complete. After this bit is cleared, it is
necessary to wait for the flash memory read setup time (t
Bit 6
V
0
1
Note: The power supply system used for the flash memory is switched by means of the VppE bit.
PP
PP
E
After switching, operation is not guaranteed during the period before the power supply
system stabilizes. It is therefore prohibited to fetch from flash memory and execute an
instruction that sets or resets the VppE bit.
12.6 V).
PP
Enable (V
Description
[Clear conditions]
This is the regular operational mode when a voltage exceeding
VH is not applied to the V
written or erased. “Hardware Protect” is displayed.
[Set conditions]
This is the operational mode when a voltage exceeding VH is
applied to the V
erased. “Hardware Protect Disabled” is displayed*.
Description
V
V
PP
PP
pin 12-V power supply is disabled
pin 12-V supply is enabled
PP
E): Disables or enables 12-V application to the V
PP
PP
pin. The flash memory can be written and
): Programming power bit (V
PP
pin. The flash memory cannot be
575
FRS
) in order to read flash memory.
CC
PP
) detects V
+ 2 V to 11.4 V. If a voltage in
PP
= 12.0 V to 0.6 V (11.4 V to
PP
PP
pin. After this bit is
, and level is
(Initial value)
(Initial value)