XR16C872CQ EXAR [Exar Corporation], XR16C872CQ Datasheet - Page 9
![no-image](/images/no-image-200.jpg)
XR16C872CQ
Manufacturer Part Number
XR16C872CQ
Description
DUAL UART WITH 1284 PARALLEL PORT AND PLUG-AND-PLAY CONTROLLER
Manufacturer
EXAR [Exar Corporation]
Datasheet
1.XR16C872CQ.pdf
(60 pages)
XR16C872
DISCONTINUED
FUNCTION DESCRIPTION
The XR16C872 (872) is a highly integrated chip combining the functionality of two XR16C850 enhanced UART, an
IEEE 1284 bi-directional printer interface, and the PC/ISA bus Plug-and-Play (PnP) interface. The PnP interface
meets the Plug-and-Play ISA Specification Version 1.0a of May 5,1994. The PnP interface and the 1284 printer
port are both clocked for maximum performance by an external crystal oscillator of 22.1184 MHz. This clock is then
internally divided by three to obtain a 7.3728 MHz clock for the two UARTs.
CPU Bus Interface Options
The 872 has two data bus interface modes, PnP and manual. In PnP mode, the chip will interface to the PC/ISA
bus directly and automatically configure each UART and the1284 parallel port address and IRQ interrupt. Figure
2 depicts the block diagram and interface.
Plug-and-Play Mode
The PnP interface supports industry standard jumperless auto configuration procedure in the PC/ISA bus system.
With an external EEPROM chip providing the resource data for each of the logical devices, it automatically negotiates
with Windows 95 or 98 operating system and configures the operating setting for each device.
The PC host system identifies and configures each PnP device using a set of defined registers accessed on the
ISA bus through three 8-bit I/O ports. All PnP interfaces in the host system respond to these same I/O ports, so after
first sending an initiation key in order to enable all the interfaces, each interface is then isolated through the Isolation
Protocol. Even though all interfaces initially respond to the Isolation Protocol, the protocol is accomplished in such
a way that no bus contention will occur. After a given interface has been isolated it is then assigned a unique Card
Select Number (CSN) so that there after the interface can be uniquely addressed.
All PnP interfaces support a defined readable resource data structure that completely describes the total resources
required and the options supported by the interface. Resource requirements of each PnP interface are broken down
into groupings called Logical Devices, each of which can be thought of as a separate device. The two 850 UART
and the 1284 parallel data port are referred to as a logical device, for a total of three logical devices. When all resource
requirements of the entire system are known, a process of resource arbitration is invoked on the host system under
Windows operating system to determine the resources to allocate to each device. Finally, each device’s resource
usage is programmed through a set of configuration registers. Some of these configuration registers are common
to all logical devices but the bulk of the registers are accessed separately for each logical device in the interface,
with each particular logical device’s configuration registers being mapped into the PnP register set one at a time.
After configuration is complete, each PnP interface is removed from configuration mode in order to prevent accidental
erasure or modification of the interface’s configuration. To re-enable configuration mode, the initiation key must be
re-issued. The 872 uses all 16 bit address lines (A0-A15) for address decoding and supports 10 IRQ's (IRQ3-7, 9-
12 and 15). Application note #xxxx describes the operation of the PnP interface in more detail.
Rev. 1.00
Visit Exar Web Site at www.exar.com
9