AK4103A_09 AKM [Asahi Kasei Microsystems], AK4103A_09 Datasheet - Page 11

• Manufacturer Part Number: AK4103A_09
• Description: 192kHz 24-Bit DIT
• Manufacturer: AKM [Asahi Kasei Microsystems]

2. Synchronous Mode (hardware controlled)
The AK4103A when configured in synchronous mode accepts 16 - 24 bit audio samples through the audio serial port
and provides dedicated pins for the control data and allows all channel status, user data and validity bits to be serially
input through port pins. This data is multiplexed, the parity bit generated, and the bit stream is biphase-mark encoded
and driven through an RS422 line driver.
2-1. Audio Routing Mode (Transparent Mode)
The AK4103A can be configured in audio routing mode (transparent mode) by ANS pin = TRANS pin = “H”. In this
mode, the channel status(C), user data(U) and validity(V) bits must pass through unaltered. The Block Start(B) signal is
configured as an input, allowing the transmit block structure to be slaved to the block structure of the receiver. The C,
U and V are now transmitted with the current audio sample. In audio routing mode, no CRCC bytes are generated and
C bits pass through unaltered. In audio routing mode, the FS0/CSN pin changes definition to AKMODE pin. When set
“H” the AK4103A can be configured directly with the AK4112B receiver. When set “L”, it may be used with other
non-AKM receivers. Setting the part with TRANS pin = “H” and ANS pin = “L” is illegal and places the chip into a
test mode.
MS0251-E-01
ANS
H
H
L
L
Pin
BLS
C (or U,V)
LRCK
LRCK
SDTI
TRANS
(except I
(I
2
S)
H
H
L
L
2
S)
Synchronous/Asynchronous
Asynchronous mode
Synchronous mode
Figure 1. Audio routing mode timing (AKMODE pin = “0”)
C(R191)
R191
C(L0)
L0
R0
C(R0)
Table 2. Mode setting
Modes
C(L1)
L1
- 11 -
Audio routing mode
Audio Routing
Normal mode
Normal mode
(Test mode)
L31
C(L31)
U Pin ORed Control Register
V Pin ORed Control Register
C Pin ORed Control Register
C(R31)
R31
Source for C, U and V bits
C,U and V pin
C(L32)
L32
[AK4103A]
2009/01