SLIN-02E2A BEL [Bel Fuse Inc.], SLIN-02E2A Datasheet - Page 17

• Manufacturer Part Number: SLIN-02E2A
• Description: NON-ISOLATED DC/DC CONVERTERS
• Manufacturer: BEL [Bel Fuse Inc.]

Voltage Margining
Output voltage margining can be implemented in the SLIN-02E2Ax modules by connecting a resistor, R
from the Trim pin to the ground pin for margining-up the output voltage and by connecting a resistor, R
from the Trim pin to output pin for margining-down.
Monotonic Start-up and Shutdown
The SLIN-02E2Ax modules have monotonic start-up and shutdown behavior for any combination of rated input
voltage, output current and operating temperature range.
Startup into Pre-biased Output
The SLIN-02E2Ax modules can start into a prebiased output as long as the prebias voltage is 0.5V less than the
set output voltage.
Power Good
The SLIN-02E2Ax modules provide a Power Good (PGOOD) signal that is implemented with an open-drain
output to indicate that the output voltage is within the regulation limits of the power module. The PGOOD signal
will be de-asserted to a low state if any condition such as over temperature, over current or loss of regulation
occurs that would result in the output voltage going ±12.5% outside the set-point value. The PGOOD terminal
should be connected through a pull-up resistor (suggested value 100KΩ) to a source of 5VDC or lower.
January 14, 2011
NON-ISOLATED DC/DC CONVERTERS
3 Vdc - 14 Vdc Input, 0.6 Vdc - 5.5 Vdc /2 A Outputs
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel [phone] • Fax [phone] •
Circuit Configuration for margining Output voltage
MODULE
Trim
Vo
GND
Bel Power, Inc. , a subsidiary of Bel Fuse, Inc.
Rtrim
Q2
Q1
Rmargin-down
Rmargin-up
www.belfuse.com
margin-down
margin-up
17
,
,