ADC-8032A ETC [List of Unclassifed Manufacturers], ADC-8032A Datasheet - Page 12

• Manufacturer Part Number: ADC-8032A
• Description: Analog Composite to SDI Decoder
• Manufacturer: ETC [List of Unclassifed Manufacturers]

2-2 • Installation and Setup
Jumper Setup
Use the following steps to set up ADC-8032A jumpers. These steps are performed before installing
the unit in the frame, but may be repeated as required. Refer to Figure 2 for card jumper locations.
1. Using the figure above and the card silk-screening, set JP5 (Input Select) to select
2. An analog composite reference is required for Line Sync and Frame Sync modes.
3. (Optional) Using the figure above and the card silk-screening, set Jumper JP4
the input video standard:
Using the figure above and the card silk-screening, set Jumper JP3 (Ext Ref) to
determine the location from which you want to obtain external reference.
(269M Fault Reporting) to enable or disable the card’s SMPTE alarm:
(See Chapter 5, “SMPTE 269M Fault Reporting” for details on fault reporting.)
•
•
•
•
•
•
•
Set jumper on pins 1-4 (Auto) to automatically select between
NTSC and PAL (default setting)
Set jumper on pins 2-5 (PAL-M) for PAL-M decoding
Set jumper on pins 3-6 (PAL-N) for PAL-N decoding
Set jumper on pins 1-2 (Frame) to obtain the reference from the frame’s
master reference (analog reference) connector (default setting)
Set jumper on pins 2-3 (O/P8) to obtain the reference from connector 8 on
the back-plane
Set jumper on pins 1-2 (EN) to enable SMPTE fault reporting (default
setting)
Set jumper on pins 2-3 (DIS) to disable SMPTE fault reporting
Figure 2. ADC-8032A Jumper Locations
ADC-8032A User Manual (Iss. 04)