ADC-8032A ETC [List of Unclassifed Manufacturers], ADC-8032A Datasheet - Page 17

• Manufacturer Part Number: ADC-8032A
• Description: Analog Composite to SDI Decoder
• Manufacturer: ETC [List of Unclassifed Manufacturers]

ADC-8032A User Manual (Iss. 04)
INPUT
OK
ERROR
BANK A
BANK B
BANK C
IN 525
IN 625
REF OK
FREEZE
ACCESS
LED
Fine Phase Adjust Potentiometer
The RV1 Fine Phase Adjust potentiometer adjusts the board’s output delay in sub-pixel
increments, with a range of 0 (zero) to approximately 45ns.
Status and Selection LEDs
The front edge of the card features ten LEDs that display the status of the input signals, and
indicate menu function and configuration selections.
As selections are made from the menu tables, (see Chapter 4, “Using Banks” for complete bank
menu table descriptions), the LEDs display the status of the input signals for each bank, as well as
menu function and configuration selections. Basic LED displays and descriptions are provided in
the following table:
Green
Red
Green
Green
Green
Green
Green
Green
Yellow
Yellow
Color
When lit, this LED indicates that the card is functioning normally and that no
anomalies have been detected. Both of the following conditions must be satisfied:
• A valid input signal is present
• A valid reference signal is present when a reference is required, and
When lit, this LED indicates that conditions for INPUT OK are not met.
Mutually exclusive with INPUT OK LED.
When lit, this LED confirms that Bank A is selected.
When lit, this LED confirms that Bank B is selected.
When lit, this LED confirms that Bank C is selected.
Lights when the input signal is 525-lines (NTSC or PAL-M).
Lights when the input signal is 625-lines (PAL or PAL-N).
When lit, this LED indicates a reference signal is present at the Master REF or BNC
input, and that the reference signal is locked.
• On = External reference standard matches the input standard
• Flashing = External reference standard does not match the input
• Off = No external reference is present
When lit, this LED indicates that any freeze mode is enabled (both models).
When lit, this LED indicates that Switch Access is unlocked. See Bank A Functions,
Mode Select position F. All changes made with Mode Select will affect
ADC-8032A operation.
that the reference standard matches the input standard. Selecting
Line Sync or Frame Sync modes require that a reference signal is
present
standard
Table 1. Selection and Status LED Descriptions
Display and Description
User Controls • 3-3