MAX17006EVKIT+ Maxim Integrated, MAX17006EVKIT+ Datasheet - Page 6

• Manufacturer Part Number: MAX17006EVKIT+
• Description: Battery Management 1.2MHz Low-Cost High-Performance Chargers
• Manufacturer: Maxim Integrated
• Series: MAX17005, MAX17006, MAX17015r

Specifications of MAX17006EVKIT+

• Operating Supply Voltage: - 0.3 V to + 30 V
• Charge Safety Timers: Yes
• Operating Supply Current: +/- 1 uA
• Product Type: Charge Management
• Temperature Monitoring: No
• Uvlo Start Threshold: 7.9 V
• Uvlo Stop Threshold: 8.9 V

MAX17006 Evaluation Kit
Jumper JU3 places the charger in shutdown mode. To
place the charger in shutdown mode, install a shunt
across jumper JU3. To enable the charger, remove the
shunt at jumper JU3 and apply the appropriate analog
DC voltage or PWM signal at ISET. See Table 3 for
proper jumper configuration to place the charger in
shutdown mode.
Table 3. Battery Charger Control
(Jumper JU3)
6
Not installed
POSITIONS
Installed
SHUNT
_______________________________________________________________________________________
Charger enabled and charge current set by R9
EV KIT CHARGE MODE
or PWM signal at ISET
Charger disabled
Charger Shutdown
The MAX17006 EV kit features an analog output test
point (IINP) to monitor the adapter current through
sense resistor R1. The measured current is the sum of
the current applied at SYS_LOAD and the battery-
charge current. The system current can be estimated
using the following equation:
I
INPUT
=
R
1
×
R
6 2 8 .
V
×
IINP
IINP Output Signal
m A V