S9S08SG8E2VTJR Freescale Semiconductor, S9S08SG8E2VTJR Datasheet - Page 47

• Manufacturer Part Number: S9S08SG8E2VTJR
• Description: 8-bit Microcontrollers - MCU 9S08 UC W/ 8K 0.25UM SGF
• Manufacturer: Freescale Semiconductor

Specifications of S9S08SG8E2VTJR

• Rohs: yes
• Core: HCS08
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 40 MHz
• Program Memory Size: 8 KB
• Data Ram Size: 512 B
• On-chip Adc: Yes
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: TSSOP-20
• Mounting Style: SMD/SMT
• A/d Bit Size: 10 bit
• A/d Channels Available: 12
• Interface Type: I2C, SCI, SPI
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 16
• Number Of Timers: 3
• Program Memory Type: Flash
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 2.7 V

4.3
The registers in the MC9S08SG32 Series are divided into these groups:
Direct-page registers can be accessed with efficient direct addressing mode instructions. Bit manipulation
instructions can be used to access any bit in any direct-page register.
user-accessible direct-page registers and control bits.
The direct page registers in
only the lower byte of the address. Because of this, the lower byte of the address in column one is shown
in bold text. In
Table
bit names to the right. Cells that are not associated with named bits are shaded. A shaded cell with a 0
indicates this unused or reserved bit always reads as a 0 and should be written as 0. A shaded cell with a 1
indicates this unused or reserved bit always reads as a 1and should be written as 1. Shaded cells with dashes
indicate unused or reserved bit locations that could read as 1s or 0s.
Freescale Semiconductor
•
•
•
4-3, and
Because the nonvolatile register locations are FLASH memory, they must be erased and
programmed like other FLASH memory locations.
Direct-page registers are located in the first 128 locations in the memory map; these are accessible
with efficient direct addressing mode instructions.
High-page registers are used much less often, so they are located above 0x1800 in the memory
map. This leaves more room in the direct page for more frequently used registers and RAM.
The nonvolatile register area consists of a block of 16 locations in FLASH memory at
0xFFB0–0xFFBF. Nonvolatile register locations include:
— NVPROT and NVOPT are loaded into working registers at reset
— An 8-byte backdoor comparison key that optionally allows a user to gain controlled access to
Register Addresses and Bit Assignments
secure memory
Table
Table 4-3
4-4, the register names in column two are shown in bold to set them apart from the
and
Table 4-2
Table
4-4, the whole address in column one is shown in bold. In
can use the more efficient direct addressing mode, which requires
MC9S08SG32 Data Sheet, Rev. 8
Table 4-2
is a summary of all
Chapter 4 Memory
Table
4-2,
41