MC68HC908QT1VDW Freescale Semiconductor, MC68HC908QT1VDW Datasheet - Page 34

• Manufacturer Part Number: MC68HC908QT1VDW
• Description: 8-bit Microcontrollers - MCU 8 Bit 8MHz
• Manufacturer: Freescale Semiconductor

Specifications of MC68HC908QT1VDW

• Product Category: 8-bit Microcontrollers - MCU
• Core: HC08
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 8 MHz
• Program Memory Size: 1.5 KB
• Data Ram Size: 128 B
• On-chip Adc: No
• Operating Supply Voltage: 3.3 V to 5.5 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: SOIC-8
• Mounting Style: SMD/SMT
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 6
• Number Of Timers: 2
• Program Memory Type: Flash
• Factory Pack Quantity: 96
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 2.7 V

Memory
ERASE — Erase Control Bit
PGM — Program Control Bit
2.6.2 FLASH Page Erase Operation
Use the following procedure to erase a page of FLASH memory. A page consists of 64 consecutive bytes
starting from addresses $XX00, $XX40, $XX80, or $XXC0. The 48-byte user interrupt vectors area also
forms a page. Any FLASH memory page can be erased alone.
In applications that require more than 1000 program/erase cycles, use the 4 ms page erase specification
to get improved long-term reliability. Any application can use this 4 ms page erase specification. However,
in applications where a FLASH location will be erased and reprogrammed less than 1000 times, and
speed is important, use the 1 ms page erase specification to get a shorter cycle time.
34
10. After time, t
1. Set the ERASE bit and clear the MASS bit in the FLASH control register.
2. Read the FLASH block protect register.
3. Write any data to any FLASH location within the address range of the block to be erased.
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Clear the ERASE bit.
8. Wait for a time, t
9. Clear the HVEN bit.
This read/write bit configures the memory for erase operation. ERASE is interlocked with the PGM bit
such that both bits cannot be equal to 1 or set to 1 at the same time.
This read/write bit configures the memory for program operation. PGM is interlocked with the ERASE
bit such that both bits cannot be equal to 1 or set to 1 at the same time.
1 = Erase operation selected
0 = Erase operation unselected
1 = Program operation selected
0 = Program operation unselected
Programming and erasing of FLASH locations cannot be performed by
code being executed from the FLASH memory. While these operations
must be performed in the order as shown, but other unrelated operations
may occur between the steps.
A page erase of the vector page will erase the internal oscillator trim values
at $FFC0 and $FFC1.
RCV
(typical 1 μs), the memory can be accessed in read mode again.
NVS
Erase
NVH
(minimum 10 μs).
(minimum 5 μs).
(minimum 1 ms or 4 ms).
MC68HC908QY/QT Family Data Sheet, Rev. 6
CAUTION
NOTE
Freescale Semiconductor