TE28F160C3TC90 Intel, TE28F160C3TC90 Datasheet - Page 19
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
TE28F160C3TC90
Manufacturer Part Number
TE28F160C3TC90
Description
IC FLASH 16MBIT 90NS 48TSOP
Manufacturer
Intel
Specifications of TE28F160C3TC90
Rohs Status
RoHS non-compliant
Format - Memory
FLASH
Memory Type
Advanced + Boot Block FLASH
Memory Size
16M (1M x 16)
Speed
90ns
Interface
Parallel
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
48-TSOP
Other names
845207
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TE28F160C3TC90
Manufacturer:
INTEL
Quantity:
20 000
4.0
4.1
4.1.1
4.1.2
Datasheet
Modes of Operation
Read Mode
The flash memory has four read modes (read array, read identifier, read status, and CFI query), and
two write modes (program and erase). Three additional modes (erase suspend to program, erase
suspend to read, and program suspend to read) are available only during suspended operations.
Table 7, “Command Bus Operations” on page 24
Descriptions” on page 25
“Write State Machine States” on page 50
Read Array
When RP# transitions from V
respond to the read-control inputs (CE#, address inputs, and OE#) without any additional CUI
commands.
When the device is in read array mode, four control signals control data output.
In addition, the address of the desired location must be applied to the address pins. If the device is
not in read-array mode, as would be the case after a Program or Erase operation, the Read Array
command (0xFF) must be issued to the CUI before array reads can occur.
Read Identifier
The read-identifier mode outputs three types of information: the manufacturer/device identifier, the
block locking status, and the protection register. The device is switched to this mode by issuing the
Read Identifier command (0x90). Once in this mode, read cycles from addresses shown in
retrieve the specified information. To return to read-array mode, issue the Read Array command
(0xFF).
•
•
•
•
WE# must be logic high (V
CE# must be logic low (V
OE# must be logic low (V
RP# must be logic high (V
summarize the commands used to reach these modes.
IL
IL
IL
IH
IH
(reset) to V
)
)
)
)
Intel
is a comprehensive chart showing the state transitions.
IH
, the device defaults to read-array mode and will
£
Advanced+ Boot Block Flash Memory (C3)
and
Table 8, “Command Codes and
Appendix A,
Table 6
19