MAX6965ATE+ Maxim Integrated Products, MAX6965ATE+ Datasheet - Page 13

• Manufacturer Part Number: MAX6965ATE+
• Description: IC LED DRIVER LINEAR 16-TQFN
• Manufacturer: Maxim Integrated Products
• Type: Linear (I²C Interface)r

Specifications of MAX6965ATE+

• Topology: Open Drain, PWM
• Number Of Outputs: 9
• Internal Driver: Yes
• Type - Primary: Backlight, LED Blinker
• Type - Secondary: RGB, White LED
• Frequency: 400kHz
• Voltage - Supply: 2 V ~ 3.6 V
• Voltage - Output: 7V
• Mounting Type: Surface Mount
• Package / Case: 16-TQFN Exposed Pad
• Operating Temperature: -40°C ~ 125°C
• Current - Output / Channel: 50mA
• Internal Switch(s): Yes
• Number Of Segments: 6
• Operating Supply Voltage: 2 V to 3.6 V
• Maximum Supply Current: 110 uA
• Maximum Power Dissipation: 1176 mW
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Efficiency: -
• Lead Free Status / Rohs Status: Details

Table 6. Blink Phase 0 Register
Table 7. Blink Phase 1 Register
Table 8. PWM Application Scenarios
All outputs static without PWM
A mix of static and PWM outputs, with PWM
outputs using different PWM settings
A mix of static and PWM outputs, with PWM
outputs all using the same PWM setting
All outputs PWM using the same PWM
setting
Read-back outputs phase 0
Read-back outputs phase 1
Write outputs phase 0
Write outputs phase 1
APPLICATION
9-Output LED Driver with Intensity Control
REGISTER
REGISTER
______________________________________________________________________________________
R/W
R/W
Set the master, O8 intensity register 0x0E to any value from 0x00 to 0x0F.
The global intensity G bit in the configuration register is don't care.
The output intensity registers 0x10 through 0x13 are don't care.
Set the master, O8 intensity register 0x0E to any value from 0x10 to 0xFF.
Clear global intensity G bit to 0 in the configuration register to disable global intensity
control.
For the static outputs, set the output intensity value to 0xF.
For the PWM outputs, set the output intensity value in the range 0x0 to 0xE.
As above. Global intensity control cannot be used with a mix of static and PWM
outputs, so write the individual intensity registers with the same PWM value.
Set the master, O8 intensity register 0x0E to any value from 0x10 to 0xFF.
Set global intensity G bit to 1 in the configuration register to enable global intensity
control.
The master, O8 intensity register 0x0E is the only intensity register used.
The output intensity registers 0x10 through 0x13 are don't care.
0
1
0
1
ADDRESS
ADDRESS
and Hot-Insertion Protection
CODE
CODE
(hex)
(hex)
0x01
0x09
OP7
OP7
D7
D7
RECOMMENDED CONFIGURATION
OP6
OP6
D6
D6
OP5
OP5
D5
D5
REGISTER DATA
REGISTER DATA
OP4
OP4
D4
D4
OP3
OP3
D3
D3
OP2
OP2
D2
D2
OP1
OP1
D1
D1
OP0
OP0
D0
D0
13