MAX8543EEE+ Maxim Integrated Products, MAX8543EEE+ Datasheet - Page 11

• Manufacturer Part Number: MAX8543EEE+
• Description: IC CNTRLR STEP DOWN 16-QSOP
• Manufacturer: Maxim Integrated Products
• Type: Step-Down (Buck)r

Specifications of MAX8543EEE+

• Internal Switch(s): No
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 0.8 ~ 11 V
• Current - Output: 25A
• Frequency - Switching: 200kHz ~ 1MHz
• Voltage - Input: 3 ~ 13.2 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-QSOP
• Power - Output: 667mW
• Output Voltage: 0.8 V to 11.88 V
• Output Current: 25000 mA
• Mounting Style: SMD/SMT
• Switching Frequency: 200 KHz to 1000 KHz
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Synchronous Pin: Yes
• Topology: Buck
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MAX8543
13
14
15
16
—
—
—
—
Lossless Sensing, Synchronization, and OVP
Step-Down Controllers with Prebias Startup,
PIN
MAX8544
16
17
18
19
10
11
20
______________________________________________________________________________________
1
SYNCO
FSYNC
NAME
MODE
ILIM2
POK
BST
DH
LX
Inductor Connection
High-Side MOSFET Gate-Driver Output. Connect DH to the gate of the high-side
external MOSFETs. DH is pulled low in shutdown.
Boost Capacitor Connection. Connect a 0.1µF or larger ceramic capacitor from BST to
LX. BST provides power for the high-side MOSFET gate drive.
Frequency Set and Synchronization. Connect a resistor from FSYNC to GND to set the
switching frequency or drive with a clock signal to synchronize between 160kHz and
1.2MHz. See the Switching Frequency and Synchronization section.
Analog Programmable Current-Limit Input for Low-Side MOSFET (V
Connect a resistor from ILIM2 to ground to set the overcurrent threshold. See the
Setting the Current Limits section.
Current-Limit Operating-Mode Selection. Connect MODE to VL for latch-off current limit
or connect to GND for automatic-recovery current limit with the MAX8544. The MAX8543
always uses automatic-recovery current limit.
Power-OK. POK is an open-drain output that is high impedance when the output is
above 91% of its nominal regulation voltage. POK is pulled low when the output is out
of regulation and when the part is in shutdown. To use POK as a logic-level signal,
connect a pullup resistor from POK to the logic supply.
Synchronization Output. Provides a clock output that is 180° out of phase with the rising
edge of DH for out-of-phase synchronization of another MAX8544.
FUNCTION
Pin Description (continued)
LX
- V
PGND
).
11