L5973AD STMicroelectronics, L5973AD Datasheet - Page 3

• Manufacturer Part Number: L5973AD
• Description: IC REG SW 2A STEPDOWN 8-SOIC
• Manufacturer: STMicroelectronics
• Type: Step-Down (Buck)r

Specifications of L5973AD

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 1.24 ~ 35 V
• Current - Output: 2A
• Frequency - Switching: 500kHz
• Voltage - Input: 4 ~ 36 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width) Exposed Pad, 8-eSOIC. 8-HSOIC
• Power - Output: 2.25W
• Output Voltage: 35 V
• Output Current: 2 A
• Input Voltage: 4 V to 36 V
• Switching Frequency: 500 KHz
• Operating Temperature Range: - 40 C to + 150 C
• Mounting Style: SMD/SMT
• Duty Cycle (max): 100 %
• Low Dropout Operation: 100 % duty cycle
• For Use With: 497-4134 - EVAL BOARD FOR L5973 SERIES497-4133 - EVAL BOARD FOR L5973 SERIES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-1417-5; 497-1417-5; 497-4565-5; E-L5973AD

L5973AD
1
1.1
1.2
Pin settings
Pin connection
Figure 2.
Pin description
Table 1.
N°
1
2
3
4
5
6
7
8
COMP
SYNC
VREF
Pin connection (top view)
Pin description
Type
GND
OUT
VCC
INH
FB
COMP
Regulator output.
Master/slave synchronization. When it is open, a signal synchronous with the
turn-off of the internal power is present at the pin. When connected to an
external signal at a frequency higher than the internal one, then the device is
synchronized by the external signal.
Connecting together the SYNC pin of two devices, the one with the higher
frequency works as master and the other one, works as slave.
A logical signal (active high) disables the device. With IHN higher than 2.2 V
the device is OFF and with INH lower than 0.8V, the device is ON.
If INH is not used the pin must be grounded. When it is open, an internal pull-
up disables the device.
E/A output to be used for frequency compensation.
Stepdown feedback input. Connecting the output voltage directly to this pin
results in an output voltage of 1.235 V. An external resistor divider is required
for higher output voltages (the typical value for the resistor connected
between this pin and ground is 4.7 K).
Reference voltage of 3.3 V. No filter capacitor is needed to stability.
Ground.
Unregulated DC input voltage.
SYNC
OUT
INH
Doc ID 9552 Rev 9
1
2
3
4
D98IN955
Description
8
7
6
5
VCC
GND
VREF
FB
Pin settings
3/22