HCPL-7710-000E Avago Technologies US Inc., HCPL-7710-000E Datasheet - Page 15

• Manufacturer Part Number: HCPL-7710-000E
• Description: OPTOCOUPLER CMOS 12MBD 8-DIP
• Manufacturer: Avago Technologies US Inc.
• Type: Logicr

Specifications of HCPL-7710-000E

• Package / Case: 8-DIP (0.300", 7.62mm)
• Voltage - Isolation: 3750Vrms
• Number Of Channels: 1, Unidirectional
• Current - Output / Channel: 10mA
• Data Rate: 12.5MBd
• Propagation Delay High - Low @ If: 20ns
• Input Type: Logic
• Output Type: Push-Pull, Totem-Pole
• Mounting Type: Through Hole
• Isolation Voltage: 3750 Vrms
• Maximum Continuous Output Current: 10 mA
• Maximum Fall Time: 0.008 us
• Maximum Forward Diode Current: 10 mA
• Output Device: Logic Gate Photo IC
• Configuration: 1 Channel
• Maximum Baud Rate: 12.5 MBd
• Maximum Power Dissipation: 150 mW
• Maximum Operating Temperature: + 100 C
• Minimum Operating Temperature: - 40 C
• Package Type: 8-Pin DIP
• No. Of Channels: 1
• Optocoupler Output Type: Gate Drive
• Input Current: 10µA
• Output Voltage: 5V
• Opto Case Style: DIP
• No. Of Pins: 8
• Common Mode Ratio: 10000
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 516-1480-5

15
Isolated Node Providing Power to the Network
Figure 21 shows a node providing power to the
network. The AC line powers a regulator which provides
five (5) volts locally. The AC line also powers a 24 volt
isolated supply, which powers the network, and another
five-volt regulator, which, in turn, powers the transceiv-
er and isolated (network) side of the two optocouplers.
This method is recommended when there are a limited
number of devices on the network that don’t require
much power, thus eliminating the need for separate
power supplies.
Figure 21. Isolated node providing power to the network.
DRAIN/SHIELD
SIGNAL
POWER
DEVICENET NODE
NODE/APP SPECIFIC
HCPL
0710
TRANSCEIVER
uP/CAN
HCPL
0710
HCPL-0710 fig 20
5 V REG.
5 V REG.
More importantly, the unique “dual-inverting” design
of the HCPL-x710 ensure the network will not “lock-up”
if either AC line power to the node is lost or the node
powered-off. Specifically, when input power (V
the HCPL-x710 located in the transmit path is eliminat-
ed, a RECESSIVE bus state is ensured as the HCPL-x710
output voltage (V
SWITCHING
ISOLATED
SUPPLY
POWER
AC LINE
O
) go HIGH.
V+ (SIGNAL)
V– (SIGNAL)
V+ (POWER)
V– (POWER)
GALVANIC
ISOLATION
BOUNDARY
DD1
) to