FW300F1 Lineage Power, FW300F1 Datasheet - Page 12

• Manufacturer Part Number: FW300F1
• Description: CONVERTER DC/DC 3.3V 198W OUT
• Manufacturer: Lineage Power
• Series: FW300r
• Type: Isolated with Remote On/Offr

Specifications of FW300F1

• Output: 3.3V
• Number Of Outputs: 1
• Power (watts): 198W
• Mounting Type: Through Hole
• Voltage - Input: 36 ~ 75V
• Package / Case: Module
• 1st Output: 3.3 VDC @ 60A
• Size / Dimension: 4.60" L x 2.40" W x 0.53" H (116.8mm x 61mm x 13.5mm)
• Power (watts) - Rated: 198W
• Operating Temperature: -40°C ~ 100°C
• Efficiency: 79%
• Approvals: CE, CSA, UL, VDE
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• 3rd Output: -
• 2nd Output: -
• 4th Output: -

dc-dc Converters; 36 to 75 Vdc Input, 3.3 Vdc Output; 165 W to 198 W
Feature Descriptions
Output Voltage Set-Point Adjustment
(Trim)
Figure 20. Resistor Selection for Decreased Output
Figure 21. Circuit Configuration to Increase
12
12
100k
10k
1M
1k
V
ON/OFF
CASE
V
I
I
(continued)
(+)
(-)
0
Voltage
Output Voltage
PERCENT CHANGE IN OUTPUT VOLTAGE ( %)
SENSE(+)
SENSE(-)
10
V
TRIM
V
O
O
(+)
(-)
(continued)
20
R
adj-up
30
R
LOAD
8-1171 (C).g
8-715 (C).b
40
Figure 22. Resistor Selection for Increased Output
Output Overvoltage Protection
The output voltage is monitored at the V
pins of the module. If the voltage at these pins exceeds
the value indicated in the Feature Specifications table,
the module will shut down and latch off. Recovery from
latched shutdown is accomplished by cycling the dc
input power off for at least 1.0 s or toggling the primary
referenced on/off signal for at least 1.0 s.
Output Current Monitor
The CURRENT MON pin provides a dc voltage propor-
tional to the dc output current of the module given in
the Feature Specifications table. For example, on the
FW250F1, the V/A ratio is set at 65 mV/A
70 C case. At a full load current of 50 A, the voltage on
the CURRENT MON pin is 3.25 V. The current monitor
signal is referenced to the SENSE(–) pin on the sec-
ondary and is supplied from a source impedance of
approximately 2 k . It is recommended that the CUR-
RENT MON pin be left open when not in use, although
no damage will result if the CURRENT MON pin is
shorted to secondary ground. Directly driving the CUR-
RENT MON pin with an external source will detrimen-
tally affect operation of the module and should be
avoided.
100k
10M
10k
1M
0
Voltage
PERCENT CHANGE IN OUTPUT VOLTAGE (
2
4
Tyco Electronics Corp..
6
O
(+) and V
July 2002
10% @
8
8-1172 (C).f
%
)
O
(–)
10