IPM12C0A0S04FA Delta Electronics, IPM12C0A0S04FA Datasheet - Page 7

• Manufacturer Part Number: IPM12C0A0S04FA
• Description: POWER MOD DC/DC 0.9 5V 4A SMD
• Manufacturer: Delta Electronics
• Series: DELPHIr
• Type: Point of Load (POL) Non-Isolatedr

Specifications of IPM12C0A0S04FA

• Output: 0.9 ~ 5V
• Number Of Outputs: 1
• Power (watts): 20W
• Mounting Type: Surface Mount
• Voltage - Input: 8 ~ 14V
• Package / Case: 7-SMD Module
• 1st Output: 0.9 ~ 5 VDC @ 4A
• Size / Dimension: 0.70" L x 0.59" W x 0.31" H (17.8mm x 15mm x 7.8mm)
• Power (watts) - Rated: 20W
• Operating Temperature: -40°C ~ 113°C
• Efficiency: 91%
• Approvals: CE, cUL, TUV, UL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• Other names: 941-1021-2

8.2 Output Characteristics
8.2.1 Line Regulation
Line Regulation Deviation is defined as the change in output voltage caused by varying the
input voltage over a specif
Test
1) Turn on the fan.
2 Set the output power to the desired operating point.
3) Se
4) Adjust the input voltage across the converter’s input range (refer to specified range) while
5) Note the maximum +/- deviation of the output voltage over the
8.2.2 Load Regulation
Load Regulation Deviation is defined as the changes in output voltage caused by varying the
output load current over th
te
Test
1) Turn on the fan.
2
3) Se
4) Adjust the output
5) Note the maximum +/- deviation of the output voltage over the full range of
8.2.3 Output Ripple
Output Ripple is defined as the periodic AC component on the DC/DC converter’s output
voltage. The output ripp
w
Test
1) Turn on the fan.
2
3) Ad
4) Adjust channel 2 on the oscilloscope to be AC coupled at 1µS/Div a
5)
)
) Set the input voltage to the desired operating level while monitoring DMM2.
) Set the switch SW1 to the “OFF” position to enable the converter.
ith a specific bandwidth.
mperature remain constant.
monitoring DMM2.
operating voltage (please refer to the data sheet for the detailed specification).
load range (please refer to the data sheet for the detailed specificat
load current.
20 MHz bandwidth-limit option on the scope.
The output rip
t the switch SW1 to the “OFF” position to enable the converter.
t the switch SW1 to the “OFF” position to enable the converter.
just the input voltage while monitoring DMM2 and set the output load to the full rated
ple of the DC/DC converter is measured at full load operating power
load across the converter’s operating load range.
le is measured in terms of peak to peak and RMS values, both done
ied range while the output load and temperature remain constant.
e specified range (no load to full load) while the input voltage and
ion).
nd 10mV/Div using the
full range of the input
the operating
.
7