P0302 Terasic Technologies Inc, P0302 Datasheet - Page 10

• Manufacturer Part Number: P0302
• Description: USB BLASTER CABLE
• Manufacturer: Terasic Technologies Inc

Specifications of P0302

• Accessory Type: Download Cable
• For Use With/related Products: Altera Devices
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Hardware Setup
Hardware Setup
1–2
USB-Blaster Download Cable User Guide
Software Requirements
The USB-Blaster download cable is only available for Windows 2000,
Windows XP, and Linux systems.
Use the Quartus
The USB-Blaster download cable also supports the following:
■
■
■
■
This section describes how to install and set up the USB-Blaster download
cable for device configuration or programming.
1
Connect your USB-Blaster download cable to the circuit board as
instructed below.
1.
2.
3.
w
Quartus II Programmer (for programming and configuration)
Quartus II SignalTap
Quartus II Programmer (standalone version)
Quartus II SignalTap II logic analyzer (standalone version)
Disconnect the power cable from the circuit board.
Connect the USB cable to the USB port on your PC and to the
USB-Blaster port.
Connect the USB-Blaster download cable to the 10-pin header on the
device board.
and the circuit board connector.
For plug and header dimensions, pin names, and operating
conditions, see Chapter 2, “USB-Blaster Specifications.”
To avoid damaging the USB-Blaster cable, first unplug the cable
from the 10-pin header on the target board before unplugging
the cable from the USB port on your PC. It is safest to remove
power first from the target board before unplugging the
USB-Blaster cable.
®
II software version 4.0 or later to configure your device.
Figure 1–1
®
II Logic Analyzer (for logic analysis)
shows the USB-Blaster download cable
Altera Corporation
May 2007