TOOLSTICKUNIDC Silicon Laboratories Inc, TOOLSTICKUNIDC Datasheet - Page 8
![CARD DAUGHTER UNIVRSTY TOOLSTICK](/photos/8/98/89811/toolstickunidc_sml.jpg)
TOOLSTICKUNIDC
Manufacturer Part Number
TOOLSTICKUNIDC
Description
CARD DAUGHTER UNIVRSTY TOOLSTICK
Manufacturer
Silicon Laboratories Inc
Series
ToolStickr
Datasheet
1.TOOLSTICKUNIDC.pdf
(16 pages)
Specifications of TOOLSTICKUNIDC
Accessory Type
Daughter Card
Interface Type
USB
Operating Supply Voltage
2.7 V to 3.6 V
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
For Use With/related Products
*
For Use With
336-1345 - TOOLSTICK BASE ADAPTER336-1182 - ADAPTER USB DEBUG FOR C8051FXXX
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
336-1434
To o l St i c k U n i D C
6.2. Connecting to the Device and Downloading Firmware
This section describes how to open the IDE, open and build a project, connect to a device, and download the
firmware.
1. Open the Silicon Laboratories IDE from the Start → Programs → Silicon Laboratories menu.
2. In the IDE, go to Project → Open Project.
3. Browse to the default location C:\SiLabs\MCU\ToolStick\UniversityDC\Firmware\FeaturesDemo\.
4. Select UniDC_FeaturesDemo.wsp and click OK.
5. In the IDE, select Project → Rebuild Project.
6. Go to Options → Connection Options.
7. Select USB Debug Adapter for the Serial Adapter and JTAG for the Debug Interface, and then click OK as
shown in Figure 6.
Figure 6. Connection Options Screen
8. Go to Debug → Connect.
9. Download the code using the Download button on the menu bar, or use Alt-D.
Once these steps are completed, the firmware is built into an object file (Step 5) and downloaded to the device
(Step 9). The device is now ready to begin executing code. If all of these steps were followed successfully, the “Go”
option is enabled in the Debug menu. A green circle icon in the IDE toolbar also indicates that the device is ready
to run. If one of the steps leads to an error, make sure that the ToolStick is properly inserted in a USB port and start
again with Step 6.
8
Rev. 0.1