P0033 Terasic Technologies Inc, P0033 Datasheet - Page 17
![BOARD ADAPTER HSMC TO GPIO](/photos/8/98/89812/p0033_sml.jpg)
P0033
Manufacturer Part Number
P0033
Description
BOARD ADAPTER HSMC TO GPIO
Manufacturer
Terasic Technologies Inc
Datasheet
1.P0033.pdf
(20 pages)
Specifications of P0033
Accessory Type
Adapter Board
For Use With/related Products
Board with HSMC Connector
Lead Free Status / RoHS Status
Not applicable / Not applicable
This section describes how to use the THDB-HTG board with a Cyclone III Starter Board.
Figure 4.1 illustrates how the THDB-HTG board is connected to the Cyclone III starter board. Users need to
pay extra attention to the following two points:
1-12
4
Connecting THDB-HTG Board to a Cyclone III Starter Board
1.
2.
Observe the orientation of the HSMC connector when connecting the THDB-HTG to the Cyclone
III Starter Board.
Note that there are two LVDS pairs on the HSMC connector: the HSMC_CLK_p1/n1 (form a close
loop via R3) and HSMC_CLKIN_p2/n2 (form a close loop via R4). Therefore, using any one of the
signal in a LVDS pair under single-ended mode will prevent users from using the other signal in the
same pair.
Demonstration
This chapter illustrates how to use the THDB-HTG board to a HSTC/HSMC-interfaced host
board.
Figure 4.1 Connecting the THDB-HTG board to the Cyclone III starter board
Demonstration
15