ST7MDT20M-TEB STMicroelectronics, ST7MDT20M-TEB Datasheet - Page 20

• Manufacturer Part Number: ST7MDT20M-TEB
• Description: BOARD EMULATOR ST7-EMU3
• Manufacturer: STMicroelectronics

Specifications of ST7MDT20M-TEB

• Accessory Type: Target Board
• Processor To Be Evaluated: ST72521 and ST72321
• For Use With/related Products: ST7MDT20M-EMU3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Appendix A EMC Conformity and Safety Requirements
APPENDIX A EMC CONFORMITY AND SAFETY REQUIREMENTS
20/28
This product respects the EMC requirements of the European guideline 89/336/
EEC under the following conditions:
•
•
•
•
•
•
•
•
Any tester, equipment, or tool used at any production step, or for any
manipulation of semiconductor devices, must have its shield connected to
ground.
All provided ferrites must be attached as described in the hardware installation
instructions of the relevant user manual(s).
The product must be placed on a conductive table top, made of steel or clean
aluminum, grounded through a ground cable. Before every contact with the
emulator, the operator must touch the surface of the grounded worktable just
behind the rear panel of the ST Micro Connect box. All manipulation of finished
must be done at such a grounded worktable.
The worktable must be free of all non-antistatic plastic objects.
It is recommended that you wear an antistatic wrist or ankle strap, connected to
the antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the
powered-on tool, you must touch the surface of the grounded worktable just
behind the rear panel of the ST Micro Connect box.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any
manipulation of parts.
ST7MDT20M-EMU3 Probe User Guide