ST7MDT20M-TEB STMicroelectronics, ST7MDT20M-TEB Datasheet - Page 23

• Manufacturer Part Number: ST7MDT20M-TEB
• Description: BOARD EMULATOR ST7-EMU3
• Manufacturer: STMicroelectronics

Specifications of ST7MDT20M-TEB

• Accessory Type: Target Board
• Processor To Be Evaluated: ST72521 and ST72321
• For Use With/related Products: ST7MDT20M-EMU3 Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7MDT20M-EMU3 Probe User Guide
Note:
5 Install the replacement TEB in the EMU3 probe by inserting the male 84-pin/64-
For some TEBs, the microcontroller is mounted on a support and not soldered directly to the
board. In this case the TEB’s 84-pin and 64-pin connectors have an additional height of 5mm
to allow enough room for the microcontroller. To compensate you will need to add a 5mm
extension to the 10mm support on the DEB, as shown in
extensions are provided with your TEB and screw into the 10mm supports. However,
remember that if you install a TEB with surface mounted microcontroller later, you will have to
remove the 5mm extensions.
6 Once the TEB is firmly in place, refasten the two screws that fix the TEB to the
7 Connect the appropriate flex cable for your MCU package, as described in
8 Replace the bottom panel of the probe housing such that the flex cable feeds
9 Reconnect the probe to the ST Micro Connect box by connecting the two 80-pin
If this is the first time that you have installed a new TEB in your EMU3 probe, your
emulator and probe firmware will be updated automatically by STVD7 when you
start a debug session. For more information refer to your STVD7 User Manual .
pin connectors into the TEB’s female 84-pin/64-pin connectors (refer to
Figure 11
connection scheme.
DEB, as shown in
Section 3.1: Connecting the flex adapter to the EMU3 probe
through the slot provided.
flat cables to the ST Micro Connect connection ports on the top face of the
probe housing. For details, refer to the ST7 EMU3 Emulator User Manual .
). Because the connectors are asymmetric, there is only one possible
Figure 10
. Take care not to over-tighten the screws.
Appendix B: Changing the TEB in your EMU3 probe
Figure 11
on page 22. The 5mm
on page 10.
23/28