IS-DEV KIT-1 NKK Switches, IS-DEV KIT-1 Datasheet - Page 10

• Manufacturer Part Number: IS-DEV KIT-1
• Description: SMARTSWITCH DEVELOPMENT KIT 1
• Manufacturer: NKK Switches
• Series: SmartSwitch™r

Specifications of IS-DEV KIT-1

• Main Purpose: Switches with Programmable Display
• Utilized Ic / Part: SmartSwitch™LCD Display
• Primary Attributes: LCD Display Module, 2 Tact Switches, with Flash Memory
• Secondary Attributes: Up to 255 Pictures and Attributes
• Description/function: SMARTSWITCH Development Kit
• For Use With: 360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Embedded: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Smart Switch - Part IS-SO108
• Other names: 360-2325

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
[Address] is one byte with value of 01H to FFH and must be sent in ASCII HEX format.
[Legend Block] is 125 bytes and must be sent in ASCII HEX format.
The LCD/LED code is not transferred to LCD/LED code refresh block.
Command to download Attribute data to a specified Address
[Address] is one byte with value of 01H to FFH and must be sent in ASCII HEX format.
[Attribute block] is 16 bytes of Addresses and must be sent in ASCII HEX format.
Command to Download Pointers
Upon receiving this command, the controller transfers the data from EEPROM to internal RAM according to
the pointer. If the pointer value is zero, no transfer takes place.
Command to Download LED codes
Upon receiving this command, The LED backlights will be according to the LED codes.
Command to Download ASCII string (7x10 fonts)
Command to Download ASCII string (5x7 fonts)
IS-Dev Kit-1 Users Manual A.doc
This command downloads the Attribute data to a specified Address.
command format: 2AH [Address] [Attribute block]
transmit format:
command format: 2DH [00H] [Pointer]
transmit format:
command format: 2CH [00H] [LED code] [JB LED code]
transmit format:
command format:
transmit format:
[code] is a byte with B0 to B3 of LED code as lower nibble and B0 to B3 of JB LED code as higher
nibble.
[ASCII string] is 8 characters. The controller will make two lines of 4 characters using the 7x10 fonts.
command format:
transmit format:
[code] is a byte with B0 to B3 of LED code as lower nibble and B0 to B3 of JB LED code as higher nibble.
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
(xxH)
(xxH) (xxH) (xxAH)
(xxH) (xxH)
(xxH) (xxH) (xxAH)
(xxH) (xxH) (xxAH)
22H
22H
www.nkkswitches.com • Email [e-mail]
[06H] [code]
[07H] [code]
(xxAH)
IS-Dev Kit-1 Users Manual
(xxAH)
(xxAH)
[ASCII string]
[ASCII string]
(xxH)
(xxH)
(xxAH)
[30H]
(xxH)
[30H]
(xxH)
Page 10 of 15
0110